Determine frequency of rotor current, Electrical Engineering

Assignment Help:

A 3 phase, 6 pole induction motor is rated at 400hz, 150v, 10h.p., 3% slip at rated power output. The windage and friction loss is 200w at rated speed. With the motor operating at rated voltage, frequency, slip, and power output, determine

(a) Rotor speed,

(b) Frequency of rotor current,

(d) Power crossing the air gap,

(e) Output torque.

Related Discussions:- Determine frequency of rotor current

Describe the process control instructions, Describe the process control ins...

Describe the process control instructions STC - It sets the carry flag & does not affect any other flag CLC - it resets the carry flag to zero &does not affect any other fl

Determine the maximum value of the voltage, Q. Three waveforms seen on an o...

Q. Three waveforms seen on an oscilloscope are shown in Figure. If the horizontal scale is set to 50 ms per division (500 ms for the entire screen width), and the vertical scale is

Transfer characteristics of p-channel enhancement mosfet, Q. Explain the dr...

Q. Explain the drain and transfer characteristics of P-channel enhancement MOSFET. In p-channel enhancement MOSFET here is a n-type substrate and p doped regions under drain an

Define the tick of the property, Tick of the property, which is different f...

Tick of the property, which is different from the group (A) Ductility. (B) Resistivity. (C) Tensile strength. (D) Hardness. Ans: Tick of the pr

Equivalent circuit of unijunction transistor, Equivalent Circuit : Th...

Equivalent Circuit : The equivalent circuit of a UJT is shown in fig. The P - N junction represented in the emitter by a diode. Silicon bar being lightly doped has a high res

Necessary conditions to maintain sustained oscillation, Q. What are the nec...

Q. What are the necessary conditions to maintain sustained oscillation? The use of positive feedback that results in a feedback amplifier having closed-loop gain |Af| greater t

The direction of motion, At what velocity must a conductor 75 mm long cut a...

At what velocity must a conductor 75 mm long cut a magnetic field of flux density 0.6 T if an e.m.f. of 9 V is to be induced in it? Suppose the conductor, the field and the directi

Change in flux linkage, 1. The coil remaining stationary with respect to th...

1. The coil remaining stationary with respect to the flux, the flux varies in magnitude with time. Since no motion is involved, no energy conversion takes place. Equation gives the

RF BASED VEHICLE TRACKING SYSTEM, HOW CAN I MAKE THIS PROJECT?

HOW CAN I MAKE THIS PROJECT?

Mesh-current equation with controlled sources, Since a controlled source ac...

Since a controlled source acts at its terminals in the same manner as does an independent source, source conversion and application of KCL and KVL relations are treated identically

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages