Design and sketch a knuckle joint to transmit a tensile load, Mechanical Engineering

Assignment Help:

Give a generalized definition of factor of safety. Illustrate the factors responsible for Un-certainities in design necessitating a suitable factor of safety. How is ‘factor of safety' related by different types of loading ?

Design and sketch a knuckle joint to transmit a tensile load of 32 KN.

A V-belt drive is to transmit 15 KW to a compressor. The motor speed is 1200 rpm and the compressor pulley runs at 400 rpm. Give whole design of the drive.


Related Discussions:- Design and sketch a knuckle joint to transmit a tensile load

Simply supported beam, Simply Supported Beam: Simply Supported Beam: ...

Simply Supported Beam: Simply Supported Beam: The beam on which both ends are supported, either by point load or hinged or roller support.

Tributary lateral load, Tributary lateral load:   The question is on a f...

Tributary lateral load:   The question is on a fictitious 1965 building in Albany, NY. It was designed using the 1964 State Building Construction Code, in which Allowable Stress

Structural steels, Structural Steels Low alloy steels are utilized fo...

Structural Steels Low alloy steels are utilized for structural causes. That type of steels is needed to possess high yield stress, excellent ductility and high fatigue resist

Kinetic inversion, kinetic Inversion In a mechanism, in a kinematic cha...

kinetic Inversion In a mechanism, in a kinematic chain one of the links is fixed. One can get different mechanisms by fixing in different links in a kinematic chain. This techn

Describe fire clay and kaolinite binders, Q. Describe Fire clay and Kaolini...

Q. Describe Fire clay and Kaolinite Binders? Fire clay : Fire clay is refractory clay usually found in the coal measures. Kaolinite: Its general composition is al 2 o 3

Calculate the temperature at the center of the pipe, Heat generated uniform...

Heat generated uniformly in Stainless steel plate having k=20 W/m. 0 C. The thickness of the plate is 1cm and the heat generation rate is 500 MW/m 3 . If the two sides of the plate

Control cables and rubber parts, Control Cables: Never bend or distort con...

Control Cables: Never bend or distort control cables. This will lead to stiff operation and premature cable failure. Rubber Parts: Beware of parts containing O-rings or oil s

Determine the speed of shaft, An internal wheel B with 80 teeth is keyed to...

An internal wheel B with 80 teeth is keyed to shaft F. A fixed internal wheel with 82 teeth is concentric with B. A compound wheel DE gear with two internal wheels, D has 28 teeth

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd