Describe cope and drag pattern, Mechanical Engineering

Assignment Help:

Cope and drag pattern

These are similar to split patterns. In addition to splitting the pattern, the cope and drag halves of the patterns along with the gating and risering systems are attached separately to the metal or wooden plates along with the alignment pins (Figure.2.4). They are called the cope and drag patterns.

1905_Cope and drag pattern.png


                                                                                  Figure-Cope and drag pattern

The cope and drag moulds may be produced using these patterns separately by two moulders but they can be assembled to form a complete mould. These types of patterns are  used  for  castings  which  are  heavy  and  inconvenient  for  handling  as  also  for continuous production.


Related Discussions:- Describe cope and drag pattern

Example of equilibrium of body on the rough inclined, Example of Equilibriu...

Example of Equilibrium of body on the rough inclined: Magnitude of minimum force ' p ' that is required to move the body up the plane. At the time when ' p ' is acted with the

Define edm machine under varying cutting condition, EDM Machine under varyi...

EDM Machine under varying Cutting Condition a) All the experiments have been conducted on a Z numerically controlled (NC) oil die- sinking EDM Machine. b) The EDM Machine is

Determine the component of force , Determine the component of force: ...

Determine the component of force: The force of 500N is acting at a point subtends an angle of 60° with the horizontal. Determine the component of force along X and Y dire

Nominal strain and true strain, Nominal Strain and True Strain: Nomina...

Nominal Strain and True Strain: Nominal Strain is ratio of change in length per initial length.  Nominal strain =  Change in length / Initial length = Δ L /   L

Dryness fraction measurement - thermodynamics, Dryness fraction measurement...

Dryness fraction measurement: Sensible Hea t of Water or Heat of Liquid or Enthalpy of Liquid (h) Sol.: It is quantity of heat which is required to raise unit mass

Types of electron beam welding gun, TYPES OF ELECTRON BEAM WELDING GUN ...

TYPES OF ELECTRON BEAM WELDING GUN   Diode (Cathode - anode) Gun : In this gun, the beam shaping electrode and the emitter are both at the same electrical potentials. These

Determine force exerted by the jet, (a) Describe the terms "Fluid jet" & "V...

(a) Describe the terms "Fluid jet" & "Vane" in Fluid Machine. (b) What is impulse - momentum principal in analysis and design of turbo machines. What are the assumptions made

Manufacturing process, Deferentiate between hot working and cold working p...

Deferentiate between hot working and cold working processes

Gas turbine, what is the affect of ambient temperature on the performance o...

what is the affect of ambient temperature on the performance of GAS turbine

Hill roads - road under special conditions, Hill Roads: Alignment ...

Hill Roads: Alignment Selection and Geometric Design Standards Here, you have already learnt how an alignment of a hill road has to be selected. The selection of a g

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd