Describe about push-pull welds, Mechanical Engineering

Assignment Help:

Q Describe about Push-pull welds?

- A push-pull system employs transformers with an electrically reversed polarity arrangement wherein two transformers complement each other to form circulating welding current circuit.

- Opposing electrodes are connected to different transformers and are of opposite polarity.

- Two spot welds may be obtained simultaneously.


Related Discussions:- Describe about push-pull welds

Thermal, what is Otto cycle?

what is Otto cycle?

What are the reasons behind poor pick-up of motor cycle, (a) Why does engin...

(a) Why does engine overheat and what will happen if engine overheats? (b) Why engine does not start in wet or damp weather? (c) What may be the causes if engine dose not sta

Uniform alternate electric field, Uniform Alternate Electric Field Supp...

Uniform Alternate Electric Field Suppose a particle moves under a uniform (i.e. independent of space co-ordinates) but alternating electric field  E  given by, E = E 0  si

Formulate the equation of motion, Figure shows a reinforced concrete framed...

Figure shows a reinforced concrete framed building subjected to earthquake ground motion. The floor is rigid with the mass of each floor is shown in the figure. Formulate the equat

Explain the methods of solid modeling, Explain the Methods of solid modelin...

Explain the Methods of solid modeling The various methods for representing the solids are : (i)  Half-space method (ii)  Boundary representation method (b-rep) (iii)

Describe brazing process, Brazing is a technique of joining two similar of...

Brazing is a technique of joining two similar of dissimilar metal pieces together by heating the surfaces and by using a non-ferrous filler metal having its melting point above 42

What are preheat and interpass temperature, Q. What are Preheat and interpa...

Q. What are Preheat and interpass temperature? Preheat and interpass temperatures shall be in accordance with the applicable codes. Materials that require preheat for welding

Find the maximum permissible, A wooden cylinder (specific gravity = 0.6) of...

A wooden cylinder (specific gravity = 0.6) of circular cross - section having length L and diameter D floats in water. Find the maximum permissible (L/D) ratio so that the cylinder

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd