Define the half duplex with respect to serial communication, Electrical Engineering

Assignment Help:

With respect to serial communication define the half duplex.

Half Duplex Transmission: A channel of half duplex can send and receive, but not at same time. It's like a one-lane bridge where two-way traffic should give way so as to cross. Only one end transmits at a time, another end receives.


Related Discussions:- Define the half duplex with respect to serial communication

The programming model of 8085 microprocessor , The  programming  Model of...

The  programming  Model of 8085 Microprocessor The programming  model  of 8085 microprocessor is  shown in figure  below in this  model  various 8 bit  and 16  bit registers a

Find the new gain for the inverting-amplifier circuit, Q. An op amp has a f...

Q. An op amp has a finite gain of only 50, but is otherwise ideal. For the inverting-amplifier circuit of Figure, if R 2 = 20 k, what value of R 1 would be needed to give a gain

Give the classification of oscillators, Q. Give the classification of Oscil...

Q. Give the classification of Oscillators?  Depending on the type of the output waveform, oscillators are classified as sinusoidal (or harmonic) oscillators and relaxation osci

Determine maximum length for cable, You have been asked to help on the desi...

You have been asked to help on the design of CDU's new electric vehicle. The vehicle is to be powered by a 96V, 300A battery pack and you need to decide on the maximum length you c

Determine the self inductance of the two coils, Determine the self inductan...

Determine the self inductance of the two coils: Two coils with a coefficient of coupling of 0.6 between them are connected in series so as to magnetize (i) in the same directi

Crystal-controlled oscillator circuits, Circuits, which provide sinusoidal ...

Circuits, which provide sinusoidal waveforms, are but useful in themselves and form the basis of many other circuits, such as square and triangular waveform generators, and clocks.

Evaluate the damping ratio for the gain, A feedback control system with the...

A feedback control system with the configuration of Figure has the following parameters: K p = 0.5 V/rad, K a = 100 V/V, K m = 2.7 × 10 -4 N·m/V, J = 1.5 × 10 -5 kg·m 2 , and

What is stored program control, Q. What is Stored Program Control ? Sto...

Q. What is Stored Program Control ? Stored Program Control:Modern digital computers use stored programmed concept. Here, a program or a set of instructions to the computer is s

Issue in sub-transmission and distribution systems, Issue In Sub-Transmissi...

Issue In Sub-Transmission and Distribution Systems The major issue in Sub-transmission and Distribution systems or rather the issue confronting the power sector as an overall,

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd