Define the disadvantages of abrasive jet cutting machines, Mechanical Engineering

Assignment Help:

Define the Disadvantages of Abrasive Jet Cutting Machines

Slow material removal rate.
Stray cutting and hence accuracy is not good.
Abrasive powder cannot be reused.
Embedding of abrasive in the work piece.
A suitable dust collecting system is required.

Related Discussions:- Define the disadvantages of abrasive jet cutting machines

Find out the centroid of an area of a semicircle, Find out the centroid of ...

Find out the centroid of an area of a semicircle: Find out the centroid of an area of a semicircle illustrated in Figure. Solution You shall note that it is not p

Difference between von mises and maximum principal stress, What is the diff...

What is the difference between von-mises and maximum principal stress? What is axisymmetric, plane stress, and plane strain modeling? What is difference between a beam, spar,

Piston leaves the bottom stops , Consider the frictionless piston-cylinder ...

Consider the frictionless piston-cylinder set-up with a linear spring as is shown below. The cylinder has an internal cross-sectional area of AC = 0.1 m2. Distances y 1 and y 4

IC engines, How does an Ignition system works ?

How does an Ignition system works ?

Thermodynamics, in a closed cycle steam enters the turbine at a temperature...

in a closed cycle steam enters the turbine at a temperature of 400oc and a pressure of 4000kpa and is condensed at 10kpa

Evaluate the reactions at hinge and roller support, Evaluate the reactions ...

Evaluate the reactions at hinge and roller support: Q: A Force P = 5000N is applied at centre C of beam AB of length 5m as shown in figure given below. Find the reactio

Equivalent force f - mechanics, If Equivalent force F and F acting on rigid...

If Equivalent force F and F acting on rigid body are not in line Sol.: If equivalent force of same magnitude 'F' acting on the rigid body are not in line, then there is no c

Cutting test, Cutting Test: Once the sand blasted blade we...

Cutting Test: Once the sand blasted blade were went through the washing process. Quality Control technician will randomly pick 15 pieces of blade to go for cutting

Electron beam welding-aerospace applications, AEROSPACE APPLICATIONS ...

AEROSPACE APPLICATIONS The need for EBW as a critical fabrication process in realising elements and assemblies for spacecraft and launch vehicle programmes due to the foll

Find out the forces in members, Find out the forces in members: A brac...

Find out the forces in members: A braced support ABC is loaded as illustrated. Find out the forces in members AB, BC, BD and AD by the method of joints. Check out the results

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages