Cantilever beam stress, Mechanical Engineering

Assignment Help:
Dear Engineer!
I have an aluminum tube(6061) fixed at one end (Cantilever Beam). The length is 180” and the load on the other end is 150 lbs.
Question: What size of tubes I should have (OD, ID) on each quarter (45” each) of the total tube for not braking them?
Please provide me the formula you use, and the unit of measurements for each formula.

Related Discussions:- Cantilever beam stress

Evaluate natural frequency of damped vibrations, What are various types of ...

What are various types of damping ? Explain viscous damping. A vibrating system is defined by the following parameters : m = 4Kg, K = 10N/m, C =3N-Sec/m Evaluate (a) Na

Determine the location of the hydraulic jumps - water depths, Problem: In H...

Problem: In HEC-RAS, model this system as 1 reach with cross-sections every 2 ft. For all 3 discharges (labeled as: design, low, flood), (a) Determine the water depths 10 ft fro

Heat, how to prove heat is a path function?

how to prove heat is a path function?

Find out the recoil-velocity of the gun, Find out the recoil-velocity of th...

Find out the recoil-velocity of the gun: As shell of mass 200 gm is fired at a velocity of 50 metres/second by a gun of mass 20 kg. Find out the recoil-velocity of the gun.

What is interference, a) What is Interference and show the relation for the...

a) What is Interference and show the relation for the minimum number of teeth required for a wheel. b) Show the relations for Maximum length of path of contact and Maximum lengt

Calculate the maximum bending movement, A beam, 6 m long is simply supporte...

A beam, 6 m long is simply supported at the ends, and carries a uniformly distributed load of 15 KN/m and three loads of 10 KN, 20 KN and 30 KN acting respectively at the centre po

Machien element, assumptions made in deriving a bending formula

assumptions made in deriving a bending formula

Example of wedge friction, Example of Wedge friction: T wo blocks A...

Example of Wedge friction: T wo blocks A and B are employed to raise load of 2000 N resting on another block C by the application of force P as shown in the figure g

Wilson hartnell governor, how to design and fabricate wilson hartnell gover...

how to design and fabricate wilson hartnell governor?

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd