Rotational-mechanics, Mechanical Engineering

Assignment Help:

A straight rod of length L is released on a friction less horizontal floor in a vertical position .
As it falls( also slips) , the distance of a point on the rod from the lower end, which follows a quarter circular locus.
A) L/2   B) L/4  C) L/8  D) None.

Ans) none as no point on the rod makes circular path. Only the lower piont will shift L/2 distancefrom its initial position.


Related Discussions:- Rotational-mechanics

Estimate the viscosity of this diluted , A diluted polymer solution with a ...

A diluted polymer solution with a density of 1130 kg/m3 was extruded through a capillary tube of 3.5 mm internal diameter and 1 m long. The following results were obtained at 25°C.

Stress analysis requirements, Q. Stress analysis requirements? All othe...

Q. Stress analysis requirements? All other lines requiring review by the stress group are to be checked for adequate support, stability, excessive movement, etc. Where hand ca

Shm, How we say that motion of the follower is simple harmonic motion descr...

How we say that motion of the follower is simple harmonic motion describe in practical approch

Clutch cable model-Clutch Complaint, Clutch cable model: Ensure the cables...

Clutch cable model: Ensure the cables fitted are of the respective model and not interchanged with other model. Also ensure that the cable is genuine.

Explain heat transfer with example, Define the difference modes of Heat Tra...

Define the difference modes of Heat Transfer with examples. State one system where Heat Transfer takes place because of all modes of Heat Transfer.

Explain metal cutting tool, What is Metal Cutting Tool? A cutting tool ...

What is Metal Cutting Tool? A cutting tool (or cutter) is any tool which is used to remove material from the work piece by means of shear deformation. Cutting may be completed

Predictive control algorithms, Predictive Control Algorithms Escaping S...

Predictive Control Algorithms Escaping Scheduling Errors via Partial Look-ahead Since previously mentioned above, the heuristic priority rules that are normally utilized in

Process of a pneumatic proportional controller, Explain the process of a Pn...

Explain the process of a Pneumatic Proportional Controller and get its transfer function. What modification is needed to make it function as a proportional plus derivative controll

Mechanics of solid, derivation for varing shear stress for thin circular tu...

derivation for varing shear stress for thin circular tubes.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd