Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Q. Alloy materials control?
All low alloy and high alloy equipment components including fittings, flanges and sections of pipe and all welds shall be individually tested by Vendor to verify alloy content after assembly of Equipment or Component is completed.
The alloy content for both welds and fittings shall be within the range specified for the base metal, per applicable ASME or ASTM specification.
Frequency of testing shall be as follows:
• One test per fitting, flange, plate, head and each attachment to pressure parts.
• One test per circumferential seam and one test per longitudinal seam.
what is weldability?
Q. What do you mean by Rigid bed models? Models with rigid boundary and geometrically similar form are used in studies connected with outlet works, stilling basins, spillways
Solid Modeling Design Create a solid model for one of the following case studies listed below (all subsystems/subassemblies are indicative): Use Solid Works CAD software. A- Ca
Q. Design Gas Compressors? As gas compressors are often high investment equipment, it makes sense to locate these well away from other equipment to minimize potential fire dama
Determine the elongation of plate: Q: A steel bar AB which is having uniform thickness 2 cm, tapers from 1.5 cm to 7.5 cm uniformly in a length of 50 cm. From 1 st principle
(a) What is the use of ball race drive? (b) How should one install the bottom cone race? (c) What is the use of front fork oil seal driver body and its attachment? (d) Wha
Primitive Instancing In primitive instancing, the modeling system defines a set of primitive 3D solid shapes that are relevant to the application area. Primitive instances are
Alloy Steels: Carbon steels in their commercial forms all times comprise specific amounts of other elements. A lot of of these elements enter the steel from the ores and it is
Third Gear Position: When gear M3 on the main shaft is in mesh with gear C3 on the counter shaft then this is known as third gear position. The fixed gear M3 rotates with mai
State about the Computer-aided design Computer-aided design (CAD), high-quality character fonts, data plots, and artists' sketches all contain smooth curves and surfaces. The pa
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +91-977-207-8620
Phone: +91-977-207-8620
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd