Access and maintenance for pumps, Mechanical Engineering

Assignment Help:

Pumps should be grouped together with good maintenance access to the motor, and good personnel access to seals and suction / discharge valves. Maintenance access should allow for removal of the motor either by ‘A' frame, forklift truck or a small crane, motors should point towards the main vehicle access route. Space should be allowed for piston removal on reciprocating pumps. Always check manufacturer's drawings for any special requirements.

Pumps in acid or toxic service should be within a curbed area to contain spillage and a water wash point should be provided near the curbed area. Pumps containing flammable liquids operating above auto ignition temperature present a high fire risk and should not be sited under pipe racks or aerial coolers.


Related Discussions:- Access and maintenance for pumps

OPITZ alternative, I am looking for an alternative coding system to the OP...

I am looking for an alternative coding system to the OPITZ coding system for my essay thanks

Find out ratio of strain-energy, Find out ratio of strain-energy: A ci...

Find out ratio of strain-energy: A circular rod of diameter d and length l is fixed at one end and a torque T applied at the other. Now, if any close coiled helical spring is

Brazing vs welding, Brazing Vs Welding Following are the differences be...

Brazing Vs Welding Following are the differences between brazing and welding. (i)  In brazing, the joint surfaces are not raised to fusion point (or melted) and the joint is

Cam nomenclature, what is the meaning of translating roller follower and to...

what is the meaning of translating roller follower and total follower travel?

Difficulties with motion sickness, In designing rotating space stations to ...

In designing rotating space stations to give for artificial-gravity environments, one of the constraints that must be considered is motion sickness. Studies have shown that the neg

Wrought al alloys, Wrought Al Alloys This aluminium alloys are acquir...

Wrought Al Alloys This aluminium alloys are acquired by addition of Mn and Mg. The Al-Mn and Al-Mg alloys cannot be heat treated. Al-Mn alloy combines high ductility along wi

Monte Calro for aerodynamic load simulation.., I have experimental results ...

I have experimental results for a 2D model and a matlab script that computes the aerodynamic loads on that 2D model.When we compare experiment with the theory I have noted that the

Identification of pressure welds, Q. Identification of Pressure Welds? ...

Q. Identification of Pressure Welds? Pressure welds shall be identified as follows: a. Generally each weld shall be stamped adjacent to the weld with the welder's identity c

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd