determine the minimum dandwidth of the system - fsk and ask, Electrical Engineering

Assignment Help:

1. Data is to be transmitted using a modem at 9600 bps. Determine the minimum bandwidth of the system with the following modulation methods

(a) FSK

(b) ASK.

Use the excess bandwidth factor r = 0:5. Compare ASK and BFSK in terms of transmission bandwidth for a constant data rate.

Related Discussions:- determine the minimum dandwidth of the system - fsk and ask

Electronic voltage regulators, Electronic voltage regulators: Electron...

Electronic voltage regulators: Electronic voltage regulators operate through comparing the actual output voltage to a few internal fixed reference voltages. Any type of differ

#thermal transducers, # complete working of thermal transducers

# complete working of thermal transducers

What is right-through routing, Q. What is right-through routing? In rig...

Q. What is right-through routing? In right-through routing, originating exchange determines complete route from source to destination. No routing decisions are taken at interme

Equivalent series impedance referred to the high-voltage, Q. A 25-kVA, 2300...

Q. A 25-kVA, 2300:230-V, 60-Hz, single-phase transformer has the following parameters: resistance of high-voltage winding 1.5 , resistance of low-voltage winding 0.015 , leakage

Prepare the equation for drift velocity and mobility, Question 1: (a) O...

Question 1: (a) Outline the architecture of MIT's iLabs. Design a diagram supporting your explanation. (b) Give advantages/disadvantages of the MIT Microelectronics iLabs wi

Explain common collector configuration, Q. Explain common collector configu...

Q. Explain common collector configuration? It is called the common-collector configuration because (ignoring the power supply battery) both the signal source and the load share

Connection of shunt capacitors at 11 kv substation, Connection of Shunt Cap...

Connection of Shunt Capacitors at 11 kV Substations 11 kV automatic switched capacitor banks are installed on bus of 33 or 66 kV substations. This has the facility that the re

Microprocessor system, A burglar alarm system is controlled by a microproce...

A burglar alarm system is controlled by a microprocessor system. The system has three independent circuit each consisting of 7 passive infra red sensors. The controller can be prog

Explain daa instruction, Explain DAA instruction. DAA: The DAA instruct...

Explain DAA instruction. DAA: The DAA instruction follows the instruction ADC or ADD to adjust the result in a BCD result. The DAA instruction performs only with the AL registe

Analog electronics, what is ebers moll model

what is ebers moll model

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages