Will there be any difference between the discharge velocitie

Assignment Help Civil Engineering
Reference no: EM13548165

A 3 m high tank filled with water has a discharge valve near the bottom and another near the top.

A) If these 2 valves are opened, will there be any difference between the discharge velocities of the 2 water streams?

B) If a hose whose discharge end is left open on the ground is first connected to the lower valve and then to the higher valve, will there be any difference between the discharge rates of water for the 2 cases? Neglect frictional effects.

Reference no: EM13548165

Questions Cloud

The pipe entrance is flush and square edged : Water flows through 800 feet of 12-inch diameter iron pipe (? = 0.0018 inches) between 2 open storage tanks, whose water surface elevation difference is 16 feet. The pipe entrance is flush and square edged
Determine the force in each member : The truss shown consists of 9 members and is supported by a ball and socket at A, two short links at B, and one short link at G. Check that this truss is a simple truss, that it is completely constrained
Determine the coefficient of statics friction between : A hawser is wrapped two full times around a bollard. by exerting an 80 pound force on the free end of the hawser a dockworker can resist a force of 5000 on the other end of the hawser.
Compute the value of pb in atm when h=10 m and density : A large closed tank is pressurized as shown. A jet of fluid issues from a small hole. Assume the flow is incompressible, irrotational, quasi-steady and the only body force acting is gravity.
Will there be any difference between the discharge velocitie : If a hose whose discharge end is left open on the ground is first connected to the lower valve and then to the higher valve, will there be any difference between the discharge rates of water for the 2 cases? Neglect frictional effects.
A fan is to be selected to ventilate a bathroom whose : A fan is to be selected to ventilate a bathroom whose dimensions are 2 m x 3 m x 3 m. The air velocity is not to exceed 8 m/s to minimize vibration and noise.
Determine the acceleration of the rod : A rectangle commercial building must be laid out 200.00 ft wide and 300.00 ft long. if the steel tape used is 100.02 ft long under standard conditions, what distances would be laid out?.
Will the surveyor have to measure to locate the new station : Station 3 + 54.67 must be marked in the field. if the steel tape to be used is only 99.98 under standard conditions and if the temperature is 87 degree farenheit at the time of the measurement, how far away from the existing station mark at 0 + 79.23..
There will be 3 hurricane-free years within the next 5 years : A 10-year hurricane is subjected to occur at a given region. Determine the probability that:

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculate the vertical stress at every combination of depth

A circular plate is loaded with a total load of 60 kips distributed uniformly over the surface at a pressure of 100 psi. Calculate the vertical stress at every combination of the following: (a) Depth: 12 and 50 (b) Radial distance from the center ..

  Deflection of a simple uniformly loaded beam

Determine the deflection of a simple uniformly loaded beam by the Ritz method,using first one term, then two terms, adn finally three terms in a sine series. Why does the coefficient of sin2piex/L vanish?

  Compute the final temperature and pressure of the gas

A tank is divided into two equal chambers by an internal diaphragm. One chamber containes methane at a pressure of 500 bar and a temperature of 20 C, and the other chamber is evacuated.

  What is the mass flow rate of the refrigerant in kg per s

A vapor-compression refrigeration system, using Refrigerant 134a as the working fluid, has evaporator and condenser pressure of 1.4 bar and 12 bar, respectively.

  Determine what are the discharge and mass flow rate

Water enters the lock of a ship canal through 180 ports, each port having a 2 ft by 2 ft cross section. The lock is 900 ft long and 105 ft wide. The lock is designed so that the water surface in it will rise at a maximum rate of 6 ft/min.

  Calculate the ph of the solution

A 1.50 L buffer solution is 0.250 M in HF and 0.250 M in NaF. Calculate the pH of the solution after the addition of 0.0500 moles of solid NaOH. Assume no volume change upon the addition of base. The Ka for HF is 3.5 x 10-4.

  Why the highest head of the water in the excavation

why the highest head of the water in the excavation is mathematically guaranteed to occur on the edge of the excavation. explain in mathematical and/or physical.

  Determine what is the quality of mixture of liquid and vapor

if the mass of liquid to vapor in a mixture of saturated liquid and vapor water is 0.8, what is the quality of the mixture

  Compute data needed to stake the curve at 50 foot increments

Two Tangents intersect at a PI Station of 35+33.24 whose coordinates are N=10349.64 feet and E= 10436.79 feet. The Intersection angle (I) = 20°15'42" Right, and the azimuth of the back Tangent is 23°14'32". (This azimuth is from the PC to the PI.)

  Determine the pressures and volumes at points a-b-c and d

A 1.00 mol sample of an ideal gas (gamma = 1.40) is carried through the Carnot cycle. At point A, the pressure is 25.0 atm and the temperature is 600 K. At point C, the pressure is 1.00 atm and the temperature is 400 K.

  What is the mixed liquor suspended solids concentration

An activated sludge system treats 1500 m3/day of raw wastewater with a BOD of 250 mg/L. The reactor volume is 375 m3. The kinetic parameters were determined to be: x = 3 day-1, Y = 0.55 kg SS/kg cells, and Ks = 150 mg/L.

  Determine which is a better site for wind power generation

Two sites are being considered for wind power generation. In the first site, the wind blows steadily at 7 m/s for 3000 hours per year, whereas the second site the wind blows at 10m/s for 2000 hours per year

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd