Determine the acceleration of the rod

Assignment Help Civil Engineering
Reference no: EM13548163

1.A rectangle commercial building must be laid out 200.00 ft wide and 300.00 ft long. if the steel tape used is 100.02 ft long under standard conditions, what distances would be laid out?.

2.The motion of the 2.5-kg rod AB is guided by two small wheels which roll freely in horizontal slots. If a force P of magnitude 8 N is applied at B, determine

(a) the acceleration of the rod, (b) the reaction at A and B.

Reference no: EM13548163

Questions Cloud

Determine the coefficient of statics friction between : A hawser is wrapped two full times around a bollard. by exerting an 80 pound force on the free end of the hawser a dockworker can resist a force of 5000 on the other end of the hawser.
Compute the value of pb in atm when h=10 m and density : A large closed tank is pressurized as shown. A jet of fluid issues from a small hole. Assume the flow is incompressible, irrotational, quasi-steady and the only body force acting is gravity.
Will there be any difference between the discharge velocitie : If a hose whose discharge end is left open on the ground is first connected to the lower valve and then to the higher valve, will there be any difference between the discharge rates of water for the 2 cases? Neglect frictional effects.
A fan is to be selected to ventilate a bathroom whose : A fan is to be selected to ventilate a bathroom whose dimensions are 2 m x 3 m x 3 m. The air velocity is not to exceed 8 m/s to minimize vibration and noise.
Determine the acceleration of the rod : A rectangle commercial building must be laid out 200.00 ft wide and 300.00 ft long. if the steel tape used is 100.02 ft long under standard conditions, what distances would be laid out?.
Will the surveyor have to measure to locate the new station : Station 3 + 54.67 must be marked in the field. if the steel tape to be used is only 99.98 under standard conditions and if the temperature is 87 degree farenheit at the time of the measurement, how far away from the existing station mark at 0 + 79.23..
There will be 3 hurricane-free years within the next 5 years : A 10-year hurricane is subjected to occur at a given region. Determine the probability that:
What percentage of the total load is carried by the shaft : What would be the load carrying capacity of a 250 mm-diameter and 15 m-long timber pile driven into soft clay with an unconfined compressive strength of 40 Kpa? What percentage of the total load is carried by the shaft?
Estimate its load carrying capacity assuming a safety factor : A 12 m-long and 800 mm-diameter drilled pier is constructed in a clayey soil with a1.5 m-diameter bell at the base. The top 7 m of the clay has an average Cu of 40 Kpa and the clay underneath has a Cu of 90 Kpa

Reviews

Write a Review

Civil Engineering Questions & Answers

  Water with a static pressure of 196knm2 flows through an

water with a static pressure of 1.96knm2 flows through an 800 mm diameter pipe. a pitot tube pressure gage in this pipe

  What reduction below atmospheric pressure must be achieved

water at 150 degrees in a beaker is placed in an airtight chamber. Air is gradually pumped out of the container. What reduction below atmospheric pressure of 14.7 psi must be achieved before water boils

  Determine the final equilibrium temperature in k

The partition is free to move and allows conduction from one gas to the other without energy storage in the partition itself. The air and carbon dioxide each behave as ideal gases. Determine the final equilibrium temperature

  Determine what is the correct distance being measured

This distance is indicated correctly on a steel surveyor's tape whenused at a temperature of 70 degrees F and subjected to a pull of 10lbs. If in measuring a certain distance the tape indicatesthe distance to be 100 feet

  Explain how the stregth of the economy as a whole

Explain how the stregth of the economy as a whole could affect the marginal benefits and the marginal costs associated with a decision to purchase a home.

  Determine the average shear stress in each pin

The pins on the frame at B and C each have a diameter of 0.25 in. If these pins are subjected to double shear, determine the average shear stress in each pin.

  Calculate the pressure at the bottom of the test tube

An open test tube at 293 K is filled at the bottom with 12.1 cm of Hg and 5.6 cm of water is placed above the mercury. Calculate the pressure at the bottom of the test tube if the atmospheric pressure is 756 mm Hg.

  Determine the forces acting on the bracket at point c

The L bracket shown below is pinned to the ground at point C and attached to a single cable at points A and D that wraps around a frictionless pulley at point B. Determine the forces acting on the bracket at point C and then tension in the cable.

  Calculate entropy increase assuming constant specific heat

A paddle wheel, inserted inserted into the volume, does 720 KJ of work on the air. If the volume is 2 cubic meters, calculate the entropy increase assuming constant specific heats.

  Compute the energy loss in each bench if the radius

Specify the radius in mm to the centerline of a 90 degree bend in a 1 in type k copper tube to acheive the minimum energy loss. For such a bend carrying 250 L/min of water at 80'C, compute the energy loss.

  What is the smallest diameter particle of specific gravity

What is the terminal settling velocity of a particle with a specific gravity of 1.4 and a diameter of 0.01 mm in 20 degrees celcius water. What is the smallest diameter particle of specific gravity 1.4

  How far downstream would you establish barricades

The fire department proposes to approach the truck from the upstream side and heavily spray the truck with water to prevent an explosion. Will this help to reduce the chlorine concentration downstream?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd