Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1. Why is a dc amplifier called a dc amplifier?
2. A radio station engineer needs to test the voltage gain over several decades. What type of graph paper would be most useful in this situation?
3. Have you ever heard of Multisim? If so, what is it?
find the magnitude of the current density in a sample of silver for which conductivity equal to 6.17107 sm and
A square pulse train (i.e. square wave) with low and high voltage values of VL= 0 and VH= 2.9 volts is applied to a DC voltmeter. The voltage measured by the instrument is 0.2 volts. The same signal is applied to an 99 O resistor.
Apply the 2D-DWT using the Haar wavelet to determine the level-1 DWT coefficients.
Determine the transfer function for a first order HIGH filter with a cutoff frequency of 1000 radians per second and passband gain of 1 using Chebyshev type with 1-dB ripples on the passband.
Why Can Discrete-Time FIR Digital Filters be a Linear Phase, Why can discrete-time FIR digital filters be made exactly linear phase, whereas IIR digital filters cannot?
A 5-element uniform linear array with inter-element spacing of λ/2 is to have maximum radiation in the direction θ=60° , find the current phases , find the directions of null radiation , hence sketch the radiation pattern , find also the relative ..
Plot a FFT for each signal- For each signal, plot an FFT with amplitude units of mils pk-pk.- What is the sample frequency (fs) for each signal?
A HCS12 ATD is set to 10-bit unsigned mode. The voltage references are set to ground and 1.0V What is the ADT output for a temperature of 81 degrees The temperature sensor measures 0 to 100 degrees with an output of 10 mV/degree.
Sketch the Capacitance-Voltage characteristics for both devices based on part (d) by giving appropriate labeling to the voltage and capacitance axis. You may assume high f measurements.
Data at a rate of 2 Mbps is to be transmitted via a pass-band communication system whose carrier frequency is 500MHz. A binary antipodal system with roll-off factor of 0.2 is used for this communication.
A parallel circuit contains an AC voltage source of 3 Vrms, 100 Hz. The output of the voltage source is connected to a diode (1N4004). After the diode, connected in parallel are a 0.1uF capacitor and a 100 kohm resistor.
if an automobile battery delivers 120 A when the car is being started, and the starting process takes 6 seconds, how many electrons flow out of the battery
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd