Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
After integrating and getting C1 and C2 for the equationsof slope and deflection,Why do we use x=0 and y=0 to figure out C2, But we don't use those same boundary conditions for finding C1?
If 90% of the weight of this brown sugar is sucrose (C12H22O11), what mass of dissolved oxygen would have been required to degrade this mass of sucrose had some not been recovered from the barge prior to its dissolution and dispersion into the riv..
Water with a static pressure of 1.96kN/M2 flows through an 800 mm diameter pipe. A pitot tube pressure gage in this pipe reads a pressure of 5.88 kN/M2. How do you determine the volume flow rate (Q) of the water? (Q = 1.40 M^3/sec, V=2.79 M/sec)
A hydraulic jump is observed to occur in a channel with a mild slope at a flow rate of 20cfs/ft. If the depth before the jump is 1 ft, determine the depth after the jump.
Carnot engine working between a source temperature of T2 and sink temperature of T1 has efficiency of 25%. if the sink temperature is reduced by 20 degrees Celsius the efficiency is increased to 30%. find the source and sink temperature
A particular mixed flow pump is operating just below the point of cavitation. The pump is sited with its intake 3 m above the water level in the reservoir and delivers 0.05 m3/s.
The velocity out of the tube may be approximated by V = √(2(p-patm)/ρ), where p is the absolute tank pressure. Determine the time at which the pressure (gage) in the tank is 20 kPa if the initial pressure is 40 kPa (gage)
The shape below has a cut along the entire length of the member thus making it an open section. The uniform thickness is 0.125in. Determine the maximum shear stress for the shape. Compare the stress for this open shape to a shape without a cut.
How much of a reduction in the automobile emission rate would be required to achieve the maximum eight-hour average NAAQS for CO at steady state 9ppmv (10.3 mg/m3)?
Two pipes of identical length and material are connected in parallel. The diameter of one is twice the diameter of the other. What is the ratio of the flow rates (Q2/Q1) in the two pipes
Air flows steadily between two sections in a long, straight portion of 4 in. inside diameter pipe (D1=D2). The uniformly distributed temperature and pressure at each section are p1=100psia, p2=18.4psia, T1=540 R and T2=453 R.
A bar is under uniform axial loads. AB is 1 foot and has a area of .5 in^2 and BC is 1 foot and has an area of .3 in^2. AB has a 1000lb force putting it under tension and BC has a 500lb force putting it under compression
a well is contaminant with 340 mg/L of tetrachloride ( perchloroethylene). the water must be remediated to achieve a concentration of 0.2 mg/L ( the detention limit ).
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd