Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1.A 4-m-long steel rod must not stretch more than 3 mm and the normal stress must not exceed 150 MPa when the rod is subjected to a 10- KN axial load. Knowing that E = 200 GPa, determine the required diameter of the rod
2.An 18-m-long steel wire of 5-mm diameter is to be used in the manufacture of a pretested concrete beam.It is observed that the wire stretches 45 mm when a tensile force P is applied. Knowing that E = 200 GPa, determine (A) the magnitude of the force P, (B) the corresponding normal stress in the wire.
3.You are driving a car your metered fuel flow is 5.97x10^5 csf if at the speed you are driving you are getting 40mpg what is your speed in mph and ft/s need formulas.
determine the maximum negative moment in each span and maximum negative moment at each support. remember that live loads shall be placed so as to cause the greatest effect. specify the method that you used to determine the moments.
A substance for which k is a constant undergoes an isothermal, mechanically reversible process from initial state(P1-->V1) to (P2-->V2), where V is a molar volume. a) Starting with the definition of k, show that the path of the process is described
Determine the self weight, moment of inertia, and cross-sectional areas for the following hot rolled standard section:
A conventional consolidated drained (CD) triaxial test is conducted on sand. The cell pressure is 100 kPa, and the applied axial stress at failure is 200 kPa.
If the resultant force is directed along the boom from point A towards O, determine the values of x and z for the coordinates of point C. Set F sub B equal to 1490 N and F sub C equal to 2320 N.
An equal tangent vertical curve connects a -2% and a +3% grade. The low point of the curve is at elevation 297.88 ft. If the PVI is at elevation 295 ft, what is the design speed of the curve
What amount of depreciation will you claim for each calenderyear during the period 1972-1975?
Compare the stoichiometric air/fule ratios (AFR) for complete combustion of Benzene (C6 H6), Octane (C8 H8), and Ethanol (C2 H5 OH) in air (O2 + 3.76 N2). The only products should be CO2, H2O and N2.
A circular beam length 36 inches and diameter 1 inch is supported on the left end by a pin joint and the right end with a roller. The beam is under axial tension with forces of 1000 lbs out of each end.
A container of petrol on a set of scales is used to measure the rate at which fuel is used by an engine under test. In one test the weight measured by the scales decreases by 25.0 N in 1 hour.
a cylindrical specimen of a metal alloyed in stressed in compression. If its original and final diameters are 40.00 and 40.10 mm, respectively , and its final length is 120.00 mm, compute its original length(L0)
water flows from a lake into a steep natural channel. the water surface elevation of the lake is 97.0 with respect to the datum. the channel properties are given below. determine the flow rate in the channel
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd