What is the viscosity of the oil for the same flow in the

Assignment Help Civil Engineering
Reference no: EM13563828

1.the cost of a small dam is expected to be 40,000 now, $3,000 one year from now, 4,000 two years from now and amounts increasing by 1,000 per year through year ten, after wich they will remain constsnt. At an interest rate of 10% per year, the capatalized cost is neareast A. $81, 325 B. 127,585 C. 147,761 D. 207, 351

2.A flowrate of 1.0 L/min of oil of specific gravity 0.92 exists in this pipeline. Is this flow laminar? What is the viscosity of the oil? For the same flow in the opposite directio, what manometer reading can be expected?

Reference no: EM13563828

Questions Cloud

At what time does the minimum volume occur : The inflow to a small reservoir during a storm may be described by the equations Q=1000(1-e^-kt) where Q= flow in cfs k= runoff rate = 1.0 per hour t = time in hours The outflow through the dam gates is held constant at 800 cfs
What is the true strain and engineering strain : A 10cm long cylindrical rod of steel is elongated to become 12.1cm long by the application of a force of 10kN.
Determine the ratio of the mean velocity to the maximum : Velocities in a 200-mm-diameter circular conduit, measured at radii of 0,36,64, and 87 mm were 7.0, 6.8, 6.1, and 5.0 m/s, respectively. Find the approximate values (graphically) of the volume flow rate and the mean velocity. Also determine the ratio..
Complete mixed system that contains a single reactor : Compare the total reactor volume required for 90% removal of a substance that decays according to first-order kinetics with a rate constant of 0.05 day-1 in a Complete mixed system that contains a single reactor against a system that contains three C..
What is the viscosity of the oil for the same flow in the : A flowrate of 1.0 L/min of oil of specific gravity 0.92 exists in this pipeline. Is this flow laminar? What is the viscosity of the oil? For the same flow in the opposite directio, what manometer reading can be expected?
What is the infiltration rate how long will it take to empty : A subsurface detention basin is installed beneath a street to help prevent flooding. Water from the rain is chanelled into the basin and begins to infiltrate into the ground when it reaches 1ft
Is the state water-quality standard being met downstream : If the state standard downstream is not met, the state has informed town 1 that it must treat its sewage further so the downstream standard is met. Use a mass balance approach to show that the state%u2019s request is unfeasible.
Calculate the peak bending moment for the 4x10 roof beam : Show a clear, dimensioned FBD for the 2x10 rafters. For the 2x10 rafters calculate the peak moment in units of ft. lb. For the 4x10 roof beam, assume the 4x10 roof beam is pinned to the subsequent 10ft section over each of the interior 4x4 columns. N..
Calculate the chord length between stations : Calculate the chord lenght between stations 75.00 and 75.75 on a circular curve with a Da = 5.5 degrees (arc definition) ? Da is degree of curve not deflection angle.

Reviews

Write a Review

Civil Engineering Questions & Answers

  How fast is the water level rising in the reservoir per day

A reservoir with a length of 20 km and width of 3 km has a flood inflow of 1000 m^3/s. (a) If exit flow is restricted to 500 m^3/s, how fast is the water level rising in the reservoir per day

  How long did take for the rocket to reach that max height

At that time, there is no more fuel in the rocket engine and the rocket continues upwards in free fall (g=0 ft/sec/sec). (a) How high will the rocket reach before it begins to fall back to the campus

  What torque is required to drive the disk

A 2.25 Adisk spins within an oil-filled enclosure,having 2.4-mm clearance from flatsurfaces each side of the disk. The disk surface extends from radius 12 to 86 mm.What torque is required to drive the disk at 660 rpm if the oil's absoluteviscosity is..

  Determine the density index of the sand

The in-situ dry density of a sand is 1.72 Mg/m^3 . The maximum and minimum dry densities, determined by standard laboratory tests, are 1.81 and 1.54 Mg/m^3, respectively. Determine the density index of the sand.

  Compute the excess elastic energy e associated with this

A significant obstacle in the design of atomic weapons is theso-called delta phase instability (a type of mixed dislocation) inPu-239. This is the problem: We wish to construct a sphericalatomic bomb core out of pure delta phase (f.c.c.) Pu-239. A de..

  What concentration of ozone is sometime used as disinfectant

The 3.0-ft diameter piper is 3,400 feet long with a steady flow rate of 10,000 gal/minozone (in mg/L) should be Injected at the head of the piper so what there will be an ozone concentration of 1.0mg/L

  What force should be applied at the lower edge of the plate

A square plate of uniform thickness has a side length of 25 cm that hangs vertically from hinges at its top edge, When horizontal jet strikes the plate at its center, the plate is deflected and comes to rest at an angle of 30o to the vertical.

  If the bar is reloaded then what is the proportional limit

A circular bar of magnesiuen alloy is 750 mm long. The bar is loaded in tension to an elongation of 6.0 mm, and the load is removed. (a) what is the permanent set of the bar (b) if the bar is reloaded, what is the proportional limit

  Determine the mass flow rate of the cooling water

refrigerant 134a is compressed at steady state from 2.4 bar, 0 degrees celcius, to 12 bar, 50 degrees celcius. Refrigerant enters the compressor with a volumetric flow rate of 0.38m^3/min, and the power input to the compressor is 2.6 kW.

  Determine what is the free flow speed on specific westbound

On a specific westbound section opf highway, studies show that the speed density relationship is u=uf *[1-(k/kj)^3.5]. It is known that the capacity is 4200hehicle/hr and the jam density is 210 veh/mile.

  Determine the cycle length and distributuion of green

A simple four-leg intersection needs a 2-phase fixed-time signal. The critical flows in the N-S and E-w directions are 600 and 400 veh/hr, respectively, with a 0.95 peak-hour factor.

  What will be the percentage decrease in specific volume

Water in a hydraulic press is subjected to a pressure of 4500 psia at 68 degrees F. If the initial pressure is 15 psia, approximately what will be the percentage decrease in specific volume

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd