What is the infiltration rate how long will it take to empty

Assignment Help Civil Engineering
Reference no: EM13563827

A subsurface detention basin is installed beneath a street to help prevent flooding. Water from the rain is chanelled into the basin and begins to infiltrate into the ground when it reaches 1ft. The water table sits 29ft beneath the bottom of the basin and the soil in that distance consists of urban fill. The hydrauic conductivity of the soil is 139ft/day and the dimensions of the tank is 78ft by 13ft. What is the infiltration rate? How long will it take to empty the tank?

Reference no: EM13563827

Questions Cloud

What is the true strain and engineering strain : A 10cm long cylindrical rod of steel is elongated to become 12.1cm long by the application of a force of 10kN.
Determine the ratio of the mean velocity to the maximum : Velocities in a 200-mm-diameter circular conduit, measured at radii of 0,36,64, and 87 mm were 7.0, 6.8, 6.1, and 5.0 m/s, respectively. Find the approximate values (graphically) of the volume flow rate and the mean velocity. Also determine the ratio..
Complete mixed system that contains a single reactor : Compare the total reactor volume required for 90% removal of a substance that decays according to first-order kinetics with a rate constant of 0.05 day-1 in a Complete mixed system that contains a single reactor against a system that contains three C..
What is the viscosity of the oil for the same flow in the : A flowrate of 1.0 L/min of oil of specific gravity 0.92 exists in this pipeline. Is this flow laminar? What is the viscosity of the oil? For the same flow in the opposite directio, what manometer reading can be expected?
What is the infiltration rate how long will it take to empty : A subsurface detention basin is installed beneath a street to help prevent flooding. Water from the rain is chanelled into the basin and begins to infiltrate into the ground when it reaches 1ft
Is the state water-quality standard being met downstream : If the state standard downstream is not met, the state has informed town 1 that it must treat its sewage further so the downstream standard is met. Use a mass balance approach to show that the state%u2019s request is unfeasible.
Calculate the peak bending moment for the 4x10 roof beam : Show a clear, dimensioned FBD for the 2x10 rafters. For the 2x10 rafters calculate the peak moment in units of ft. lb. For the 4x10 roof beam, assume the 4x10 roof beam is pinned to the subsequent 10ft section over each of the interior 4x4 columns. N..
Calculate the chord length between stations : Calculate the chord lenght between stations 75.00 and 75.75 on a circular curve with a Da = 5.5 degrees (arc definition) ? Da is degree of curve not deflection angle.
What should be the outside diameter if the load is carried : A circular tube has a wall thickness of 10 mm. It is required to carry a load of 1000 kN with a factor of safety of 2.0. The length of the tube is 4 m. What should be the outside diameter if the load is carried in?:

Reviews

Write a Review

Civil Engineering Questions & Answers

  Draw the shear and moment diagram for a beam

Draw the shear and moment Diagram for a beam that is 10 feet long, supported on the left end by a roler, and the right end by a pin, and has a 1000 lb load placed in the center i.e at 5 feet.

  Find the resistive force exerted by the water on the boat

Each exerts a force of 600 N directed at a t= 20.0° anglerelative to the forward motion of the boat. If the boat moves withconstant velocity, find the resistive force exerted by the water on the boat.

  Find the value of the angle at which the projectile is fired

A projectile is fired with an initial velocity of 800 ft/s at a target B located 2000 feet above the gun A and at a horizontal distance of 12,000 feet. Neglecting air resistance, determine the value of the angle at which the projectile is fired.

  What does the water content of sludge need to be in energy

A POTW facility that operates an anaerobic digestion process generates 2200 tones of waste water sludge per year. The solids content of the raw sludge is 4% by weight.

  Property of sanstone and of the quartzite

if you had a choice of three kinds of aggregate--a sandstone,a crushed basalt,and a quartizite,you may select the basalt.Give one possible characteristic or property of sanstone and of the quartzite that made you decide not to select it for your c..

  Determining the pumping rate

Determine the required pumping rate. the aquifer has T= 1600 m 2 /day and the wells each have radius of influence of 600m.

  Compute the reynolds number for each of the cases

When working with flow through pipes , engineers typically have to determine if the flow is laminar or turbulent. Compute the Reynolds number for each of the cases below and determine if the flow is laminar or turbulent. Assume all of the conduits..

  Determine what will be the height above datum of a point b

If the free surface at a distance from the axis of the vortex, which is sufficient for its effect to be negligible, is 180 mm above datum, what will be the height above datum of a point B on the free surface at a radius of 100 mm

  Determine the time required to bring the train to a stop

The subway train shown is traveling at a speed of 30 mi/hr in the west direction when the brakes are fully applied on the wheels of cars B and C, causing them to slide on the track, but are not applied on the wheels of car A.

  Calculate the uniform flow rate in an earth-lined canal

Calculate the uniform flow rate in an earth-lined (n = 0.020) trapezoidal canal having bottom width 3 m, sides sloping 1V : 2H, laid on a slope of 0.0001, and having depth of 1.8 m.

  Determine depth result upstream during design flood event

A 1.5m diameter barrel (concrete barrel, well-rounded entrance) that is 20 m long is installed on a slope of 2 percent. The design discharge is 9.5 m^3/s and the inlet will be submerged but not the outlet.

  Calculate the amount of water to be added per cubic meter

An undisturbed soil sample has a total unit weight of 19.4 kN/m3, a dry unit weight of 16.9 kN/m3, and a specific gravity of soil solids (Gs) of 2.69. If the sample could be saturated without changing its porosity, calculate the amount of water (i..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd