What is the theoretical rate of moisture removal

Assignment Help Civil Engineering
Reference no: EM13563798

A model grain dryer is being used to investigate the drying process. It is discovered that the load cell which supports the dryer indicates that the mass of the dryer and its contentsinitially increases during the heat-up. This phenomenon is to be investigated, and it is proposed that it may be caused by either of the factors:

a. Moisture in the hot drying air condensing on the cooler grain near the plenum of the bin (Hint: The vapor in the ambient will condense out if the temperature of a surface is lower than the incoming air dew-point temperature).

b. There is a false reading in the load cell (because there is no initial condensation taking place in this particular case) Could either (a) or (b) be true? The operating parameters of the bin are:

Air mass flow rate (dry) = 0.15 kg/sec, Ambient dry bulb temperature = 23 ºC, Initial grain temperature = 20 ºC &

Plenum temperature = 40 ºC.

d.A computer simulation of the above dryer shows that towards the end of the drying time, air exits the drier at a relative humidity of 90%. What is the theoretical rate of moisture removal from the grain at this point, in kg/hr (Hint: It can be assumed that there is no heat loss through the walls, so the enthalpy of the plenum air will be the same as the enthalpy of the discharge air)

Reference no: EM13563798

Questions Cloud

Compute and tabulate the azimuths from the following 3-sided : Compute and tabulate the azimuths from the following 3-sided traverse where course ab is due north. angles are to the right. include a sketch.
Determine the work done and the heat transfer : Water, initially dry saturated vapour at 4 bar, lls a closed rigid con- tainer. The water is heated until its temperature is 400C. Determine the work done and the heat transfer.
What is the concentration of nox : It has been estimated that the emission of NOx from a coal fired power plant is 1300 g/s. At 100 km downwind (y=10m), what is the concentration of NOx in g/m^3. The wind speed at the top of the stack with a height of 100m is 6.5 m/s and an inversion ..
What is the maximum flowrate in the business can discharge : A business wishes to discharge salt into a river. the concentration of salt from the business is 210 mg/L. the flow of water in the river (upstream) is 0.5 m^3/s. Upstram the concentration of salt in the river 15 mg/L.
What is the theoretical rate of moisture removal : Moisture in the hot drying air condensing on the cooler grain near the plenum of the bin (Hint: The vapor in the ambient will condense out if the temperature of a surface is lower than the incoming air dew-point temperature).
Determine the station of the point where the superelevation : A 6 lane highway has 12 ft lanes and a crown cross-slope of 0.02 ft/ft. The design speed of the road is 60 mph. The station of the PC is 20+00. Determine the station of the point where th superelevation runoff begins
Find the minimum number of coins he has : According to his will: First give one coin to manager. 1/5th of the remaining to the elder son. Now give one coin to the manager and 1/5th of the remaining to second son and so on..... After giving coins to 5th son, divided the remaining coins among ..
What is the reason for the relatively high strength of wood : The de-carburization of a steel can also be described by the error fuction. Starting with the equation, (cx-c0)/(sc-c0) = 1-erf(x/(2*(sqrt(Dt)))), and taking cs=0 derive an expression to describe the concentration profile of carbon as it diffuses out..
Under what condition will both the soil have the same weight : A box of mass M=500 kg hangs by a rope from a beam with dimensions a=2.0 m and b=3.0 m. The beam has mass m=85 kg. Find the tension T_c in the cable and the magnitude of the net force F exerted on the beam by the hinge. (Engineering firms usually nee..

Reviews

Write a Review

Civil Engineering Questions & Answers

  Find e in terms of b and h to have one type of normal stress

For arectangular section (b(width) x h(thickness) that is subjected to aforce P that is applied at an eccentricity (e) measured from thecenter of area of the rectangle in the h (thickness) direction.

  When the local mean time at los angeles

The longitude of Albany, New York, is +73 degrees 44' 49" and the longitude of Los Angeles, California, is +118 degrees 10' 44". When the local mean time at Los Angeles is 10h 41m 00s a.m., the local mean time at Albany is

  Find the total well losses in and around the pumping well

After the cone of depression has achieved equilibrium, the piezometric heads at two observation wells 40 and 95 m from the pumping well are measured as 78.9 and 83.4 above sea level, respectively.

  How many months of use necessary for the two to break even

One can lease a car for $550 per month with no down payment or purchase one for $20,000 now. If the nominal interest rate is 8% per year, how many months of use necessary for the two to break even

  Determine the final equilibrium temperature in k

The partition is free to move and allows conduction from one gas to the other without energy storage in the partition itself. The air and carbon dioxide each behave as ideal gases. Determine the final equilibrium temperature

  Calculate the magnitude of the force supported by bearing

The uniform 25 kg plate is welded to the vertical shaft, which is supported by bearings A and B. Calculate the magnitude of the force supported by bearing B during application of the (M =) 140 N·m couple to the shaft.

  How much would end of wing deflect relative to fuselage

If the aluminum wing has an I of 745 in^4 and aluminum has an E of 10.1 *10^6 psi, how much would the end of the wing deflect relative to the fuselage of the aircraft compared to the position it has when aircraft is on the ground.

  Define need before function

Which of the following is not a basic systems engineering concept?a. Define need before function

  Find the specific heat capacity of iron at steady state

an iron cube at 400 degrees Celsius is dropped into a insulated bath containing 10kg of water  25 degrees Celsius. the water finally reaches a temperature of 50 degrees Celsius at steady state.

  Determine peak discharge if unit hydrograph is triangular

A hydrograph has a uniform rainfall intensity of 1.5 in/hr in the first hour, 2.0 in/hr in the second, and 0.75 in/hr in the third hour. Direct runoff (in inches) using the SCS method is 1.2in.

  Determine the transmissivity through a confined aquifer

A 12-in well is drilled through a confined aquifer of average thickness 80 ft. Two observation wells located 50 and 120 ft away register a difference in drawdown of 10 ft. The steady-state pumping rate is 1000 gpm

  Calculate speed of the shockwave foamed by the bottleneck

When stationary, vehicles are spaced at average distance headway of 6 m. It may be assumed that there is a linear relationship between speed and density. When the traffic flow approaching the roadworks is 3500 vehicles per hour

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd