What is the resulting solids concentration

Reference no: EM13555161

Raw primary sludge at a solids concentraion of 4% is mixed with waste activated sludge at a solids concentration of .5%. The flows are 20 and 24 gal/min respectively. What is the resulting solids concentration? This mixture is next thickened to a solids concentration of 8% solids. What are the quantities (in gal/min) of the thickened sludge and thickener overflow (water) produced? Assume perfect solids capture in the thickener.

Reference no: EM13555161

Questions Cloud

What are the northing and easting coordinates for station b : The coordinates for station A are 1023.34 N and 988.56 E. What are the northing and easting coordinates for station B that is located 40 feet due east of A, and 22.32 feet due south of A

Find the maximum allowable tensile force : A 4-cm- diameter rod of aluminum 7075-T6 is to subjected to an axial tensile force such that the factor of safety based on the yield stress on 1.75. Find the maximum allowable tensile force. The yield stress of the aluminum 7075-T6 is o-y= 500MPa.

Use the doubling time approximation to estimate : Use the doubling time approximation (3.5) to estimate the exponential rate of growth that would produce those numbers. Use the exponential growth equation (3.6) to find the growth rate

Determine the diameter of commercial steel pipe required : World population 10,000 years ago has been estimated at about 5 million. what exponential rate of growth would have resulaed in the population in 1850 , which is estimated at 1 billion ? had that rate continued , would the population have been in the..

What is the resulting solids concentration : Raw primary sludge at a solids concentraion of 4% is mixed with waste activated sludge at a solids concentration of .5%. The flows are 20 and 24 gal/min respectively.

What fraction of the flue gas stream would need to be bypass : An electrostatic precipitator for a coal-fired power plant has an overall particulate recovery of 95%. The company engineer decides that this is too good, that it is not necessary to be this efficient

What is the pressure difference measured by the manometer : The "U"-tube manometer containing mercury of density 13600 kg/cubic meters is used to measure the pressure drop along a horizontal pipe.

What tensile force should be applied to the bar to maintain : Suppose that in an apparatus it is necessary to maintain precisely the cross section of a 20mm circular nickel steel bar. If this bar is heated to 200 deg Celcius

A cast brass rod 60mm in diameter and 150mm long is compress : A cast brass rod 60mm in diameter and 150mm long is compressed axially by a uniformly distributed force of 200kN. Determine the increase in diameter caused by the applied force, E=85GPa; poisson's rato=.30

User Account

All Pages