What is the original unstretched length of the cable

Assignment Help Civil Engineering
Reference no: EM13531127

A 57.0 kg skier is being pulled up a 13.0° slope by a steelcable. The cable has a cross-sectional area of 7.18 10-5 m2. The cable applies a force tothe skier, and, in so doing, the cable stretches by 2.5110-4 m. A frictional force of 68.0 N acts on theskis and is directed opposite the skier's motion. If the skier'sacceleration up the slope has a magnitude of 1.04 m/s2,what is the original unstretched length of the cable?

F = Y (ΔL / L) A

F = 2.0x10^11 N/m^2 (2.51 x 10^-4 m / L) 7.18 x 10^-5m^2

L = ?

Reference no: EM13531127

Questions Cloud

How long does it take light traveling : The distance from a star to a planet is 3.1 * 1019 m.  How long does it take light, traveling at 1016 m/year, to travel from the star to the planet?
Calculate the mass of steam condensed during this process : A room is filled with saturated steam at 100 degrees C. Now a 5-kgbowling ball at 25 degrees C is brought to the room. Heat istransferred to the ball from the steam, and the temperature of the
With this method approximately 80liters of water are require : A meat packing plant manager is trying to decide between twodifferent methods for cooling cooked hams. the spray methodinvolves spraying water over the hams until the ham temperature isreduced to 30 degrees Celcius. With this method approximately 80l..
Estimate the tension in the rope if the wind : The intensity of Na light passing through a gold film wasmeasured to be about 15% of the incoming light. What is thethickness of the gold film? ( λ=589 nm; k=3.2).
What is the original unstretched length of the cable : A 57.0 kg skier is being pulled up a 13.0° slope by a steelcable. The cable has a cross-sectional area of 7.18 10-5 m2. The cable applies a force tothe skier
Determine the approximate drag coefficient for the parachute : A 5-m-diameter parachute of a new design is to be used to transporta load from flight altitude to the ground with an average verticalspeed of 3 m/s. The total weight of the load and theparachute is 200 N. Determine the approximate dragcoefficient for..
Do the same for saturated vapor steam in an adiabatic : Saturated liquid water is in an adiabatic compressor with inlet and outlet pressures of 100 kPa and 1 Mpa. The isentropic efficiency is 85%. Find the work input (kj/kg) and entropy generation (kj/ kg K).Do the same for saturated vapor steam in an adi..
What is the density of the rock before it blasted : You are given the following information about a dry-batchpaving operation. You are going to use one mixer that has a servicerate of 30 serives/hr. The dry-batch trucks you use forbringing concrete to the paver have an arrival rate of 7.5 arrivals/hr...
A street car line on the center of an 80 ft street makes : A street car line on the center of an 80 ft street makes a 75degrees 24' turn into another street of equal width. Thecorner curb line has R=12 ft. What's the largest R that canbe given a circular curve for the tract center line if the law requires it..

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculate the true stress for fracture in the neck region

A copper wire breaks under an engineering stress of 43x10^3 psi. Its ductility is 77%it reduction area. Calculate the true stress (in psi) for fracture in the neck region.

  Find reservoir in acre-ft that would be required to contain

A hurricane has an average rainfall of 9 in over a 200 mile^2 watershed. What is the reservoir in acre-ft that would be required to contain 20% of the rain completely

  Determine what is the tss for the sample

A rinsed and dried filter weighed 0.3588 grams before the sample was filtered and then weighed 0.3630 grams after the sample was filtered and being at dried at 103C. What is the TSS for this sample

  Explain light-voice controlling system

Light-Voice Controlling System. We are planning to design a new light-voice controlling system. The voices will basically coordinate the crossing of a road by blind people. Suppose the crossing will be operated by two coordinated systems

  Find percentage of air voids and voids in mineral aggregates

Find the percentage of Air voids and voids in the mineral aggregate if the asphalt absorption is .5%, and the specific gravities of the aggregate and binder are 2.660 and 1.020 respectively. The unit weight of the mixture is 2.39 Mg/m^3

  Find what will be the percentage change in the volume

An open vat in a food processing plant contains 400L of water at 20 degrees C and atmospheric pressure. If the water is heated to 80 degrees C, what will be the percentage change in its volume? If the vat has a diameter of 3m

  What is magnitude of total external force on the helicopter

During a test flight in which a 9000-kg helicopter starts from rest at t = 0, the acceleration of its center of mass from t =0 to t =10 s is a=(0.6t)i+ (1.8 0.36t)j m/s2.

  Provide three us and two international locations

1. Povide three non-pavement products that use asphalt and by weight, what is the percent that is asphalt 2. Provide three US and two international locations where asphalt or its parent material, crude oil, originate from for use int the US

  Determine amount of coal used per day if heat of combustion

A coal fired power plant can be modeled as a heat engine. If the power output of the plant is 200 MW and the thermal efficiency is 42%, determine the amount of coal used per day if the heat of combustion from the coal is 24,000 kJ/kg.

  What is the potential theoretical oxygen demand associated

A Waste water has been characterized for nitrogen-containing compounds and the TN was 26 mg N/L, the TKN was 14 mg N/L and nitrate was 27.3 mg NO3-/L. What is the potential theoretical oxygen demand (mg O2/L) associated

  Calculate the co-efficient of permability of the soil

In a falling-head permeability test the initial head of 1.5m dropped to 0.5m in 4 h the diameter of the standpipe being 5mm. The soil specimen was 200mm long by 100mm in diameter.

  Determine the normal and shearing stresses at point

Three forces are applied to the bar. Determine the normal and shearing stresses at (a) point a, (b) point b, (c) point c.Assuming that the 750-N force is directed vertically upward.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd