Do the same for saturated vapor steam in an adiabatic

Assignment Help Civil Engineering
Reference no: EM13531125

Saturated liquid water is in an adiabatic compressor with inlet and outlet pressures of 100 kPa and 1 Mpa. The isentropic efficiency is 85%. Find the work input (kj/kg) and entropy generation (kj/ kg K).Do the same for saturated vapor steam in an adiabatic compressor with the same pressures and efficiency.

Reference no: EM13531125

Questions Cloud

With this method approximately 80liters of water are require : A meat packing plant manager is trying to decide between twodifferent methods for cooling cooked hams. the spray methodinvolves spraying water over the hams until the ham temperature isreduced to 30 degrees Celcius. With this method approximately 80l..
Estimate the tension in the rope if the wind : The intensity of Na light passing through a gold film wasmeasured to be about 15% of the incoming light. What is thethickness of the gold film? ( λ=589 nm; k=3.2).
What is the original unstretched length of the cable : A 57.0 kg skier is being pulled up a 13.0° slope by a steelcable. The cable has a cross-sectional area of 7.18 10-5 m2. The cable applies a force tothe skier
Determine the approximate drag coefficient for the parachute : A 5-m-diameter parachute of a new design is to be used to transporta load from flight altitude to the ground with an average verticalspeed of 3 m/s. The total weight of the load and theparachute is 200 N. Determine the approximate dragcoefficient for..
Do the same for saturated vapor steam in an adiabatic : Saturated liquid water is in an adiabatic compressor with inlet and outlet pressures of 100 kPa and 1 Mpa. The isentropic efficiency is 85%. Find the work input (kj/kg) and entropy generation (kj/ kg K).Do the same for saturated vapor steam in an adi..
What is the density of the rock before it blasted : You are given the following information about a dry-batchpaving operation. You are going to use one mixer that has a servicerate of 30 serives/hr. The dry-batch trucks you use forbringing concrete to the paver have an arrival rate of 7.5 arrivals/hr...
A street car line on the center of an 80 ft street makes : A street car line on the center of an 80 ft street makes a 75degrees 24' turn into another street of equal width. Thecorner curb line has R=12 ft. What's the largest R that canbe given a circular curve for the tract center line if the law requires it..
Knowing that the coefficient of restitution between the : A 2-lb sphere A is moving to the left with a velocity of 40 ft/swhen it strikes the inclined surface of a 5-lb block B which is atrest. The block is supported by rollers and is attached to a springof constant k=12 lb/in.
Determine the required capacity of the motor of the : A step-type escalator as shown is designed to transport 120 persons per minute at a constant speed v=1.5 ft/s. The overall efficiency of the escalator is estimated to be 70%, and a 200% overload is to be allowed. Assuming that the average weight per ..

Reviews

Write a Review

Civil Engineering Questions & Answers

  How long would it take for consolidation of the clay

A 4m deep clay layer is underlain by impermeable shale. A sample of clay from the layer is subjected to an appropriate increment of stress in a consolidation test giving the following results

  Determine location of hydraulic jump relative to slope break

A rectangular channel of width 12 ft has an upstream slope of 0.02 ft/ft and a downstream slope of 0.0005 ft/ft. Both reaches have lengths of 500 ft. The upstream reach has a Manning's roughness of 0.016 and the downstream reach has a roughness of..

  Is the plant in violation of the deq discharge limit

Immediately upstream of the treatment plant, the Pine River has an ultimate CBOD of 2 mg/L and a flow of 9 × 105 m3/day. At a distance of 20 km downstream of the treatment plant, the Pine River has an ultimate CBOD of 10 mg/L.

  Why its necessary to require conditions-sand cement ratio

Why is it necessary to require such conditions-sand cement ratio, w/c ratio and type of sand. A graded sand is specified for use in the mortar cube test. What would be the likely results if a one-sized sand was used instead of a graded sand.

  Determine what is the equation for average vehicle delay

What is the equation for average vehicle delay Is it averge queue over arrivals Average queue over average arrivals

  Determine the power developed by the force

determine the power developed by the force when t = 5s. Hint: First determine the time needed for the force to cause motion.

  Use work and energy to find paul speed

Susan's 12.0 baby brother Paul sits on a mat. Susan pulls the mat across the floor using a rope that is angled 30 degrees above the floor. The tension is a constant 31.0 and the coefficient of friction is 0.210. Use work and energy to find Paul's ..

  What is the concentration of nh3of household ammonia

What is the concentration of NH3 (in mg/L) of household ammonia that contains 3.00 percent by wieght of NH3. Assume the density of water = 1000kg/m^3

  Determine the inclination of the ladder of static friction

Determine the inclination of the ladder if the coefficient of static friction between the friction pad A and the ground is = 0.3. Assume the wall at B is smooth.

  Determination of edta titration

Does the presence of Mg2+ significantly interfere with the determination of Ca 2+ by the EDTA titration?

  What is the parameter that determines the bandwidth

For a given tank circuit resonance frequency, what is the parameter that determines the bandwidth

  The voltage for registering a bit of 1 on ethernet can be

the voltage for registering a bit of 1 on ethernet can be as low as 2.5 volts or event 1 volt.why is this so low when

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd