Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1.A submerged stratum of clay has a thickness of 15m. The average water content of samples taken from the stratum is 54%, and the specific gravity of the solid constituents is 2.78. What is the effective vertical pressure, due to the weight of the clay, at the base of the stratum.
2.The initial velocity of a 15-lb block is given as mv1=15i+15j (ft/s). A force defined by F=250i-250tj (lb) acts on the particle from time t=0 to time t=0.3 s for a total duration of 0.3 s. Determine the particle’s velocity at t=1 s. Neglect friction.
In thermal expansion is a tendencyof a material to increase in size as it increase intemperature. Where the young modulusdescribes tesile elasticity. or the tendecy
Assuming a drag coefficient Cd of 0.6 for the baffle blocks based on the upstream velocity and combined frontal area of the blocks, calculate the sequent depth required to form a jump with the blocks and compare this value to the sequent depth requir..
A small chunk of the original sample had a wet weight of 140.9 grams and weighed 85.2 grams after drying. Compute the water content, using the correct number of significant figures.
An unconfined, gravel-sand aquifer has a porosity of 0.23, and a hydraulic conductivity of 1000 m/day. Two monitoring wells are 260 m apart, and the difference in their water levels is 0.3 m.
A 1 m diameter mass, M is connected to a 2 m wide rectangular gate. The gar is to open when the water level ,h, drops below 2.5 m. Determine the required value for M.
A torque of T = 3.00 kN-m will be applied to the hollow thin-walled aluminum alloy section. If the section has a uniform thickness of 4 mm, determine the magnitude of the maximum shear stress developed in the section.
At the beginning of compression the pressure is 14 psi and the temperature if 60°F. The temperature at the end of combustion heat addition is 1500°F and the compression ratio is 9. Use constant specific heats at room temperature
After drawing a free body diagram, how do you determine what the forces are in the Ax, Ay directions, etc. without being given any numbers
Determine the activated sludge aeration volume required to treat 2.64 mgd with a BOD of 120 mg/l based on the criteria of a maximum BOD loading of 40 lb/1000 ft cubed/day and a minimum aeration period of 5 hr.
this cuts it down to a single force that you have to solve for, regardless of what type of member it is. Prove that the forces are equal and that the lines of action are along an angle theta. HINT: Use to do equations of equilibrium.
Uniform deposits were made on January 1 of 1991, 1992, 1993, and 1994 into a fund intended to provide $1000 on January 1 of 2005, 2006, and 2007. What were the size of these deposits
Lane widths are 12ft and the superelevation is .006 and was set assuming maximum fs. If the necessary sight distance required 52ft of lateral clearance from the roadway center line, what design speed was used for the curve
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd