Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A symmetrical toroidal coil is wound on a plastic core (μr ≅ 1) and is found to have an inductance of 1 mH. What inductance will result if the core material is changed to a ferrite having μr = 200? Assume that the entire magnetic path is composed of ferrite.
The parameters of an n-channel enhancement-mode MOSFER are VTN = 0.5V, k'n = 120μA/v2, and W/L = 4. What is the maximum value of λ and the minimum value of VA such that for VGs = 2V, ro ≥ 200kΩ?
An amplifier operating from +/- 12 V power supplies has alinear transfer characteristic except for output saturationat+/- 11.4 V. a) The peak-to-peak value of the largest sinusoidal wave thatcanbe applied at the amplifier input without output dist..
A cylindricalsteelrod 50 cm long with a circu.lar cross section, that wrn conduct 150 J/s from a furnace at 400 °C to a container of boiling water under 1 atmosphere. Find the diameter of rod
Design a synchronous sequential circuit with one input line and one output line that recognizes the input string x = 1111. The circuit is also required to recognize overlapping sequence such that if the input string is x = 1101111111010
consider a TSI for a system with four timeslots per frame. Draw a block diagram- it should have four 2-bit words, eight 8-bit words, and a 3-bit binary counter. Walk the TSI through three consecutive frames of incoming data.
A current filament is 5 mm long and is situated at x = 0, y = 4, z = - 3 parallel to the x-axis. If the filament carries a current of 3 A along ax , find H at the origin.
There is a circuit with a 12V DC battery,500mH inductor, a 45 ohm resistor, and a switch all inseries. Suppose the switch has been closed for a very longtime when a wire is connected over just the battery.
If the input Voltage range of an ADC is from 0V to 5 V, and if 5-bit quantization is used, what is the size of each quantization step
When an RLC series circuit is connected to a 120 V rms, 60 Hz line, the rms current in the circuit is 11 A and this current leads the line voltage by 45 degrees. (a) Find the average power supplied to the circuit. (b) What is the resistance in the..
a- for this modulator a 1-v signal produces a deviation of 20Khz determine the amplitude and phase spectra of s(t) for the modulating signal m(t) = 1.5 cos(2*pi*6*10^4*t) when fc>>fm b- find the bandwidth of the modulated signal using carson's rule..
A line charge of uniform charge density (l) forms a circle of radius b that lies in the xy-plane in air with the center at the origin. a) Find the electric field intensity E at the point (0,0,h) b) At what value of h will E in part (a) be a maximum
If the controller is designed to switch the stator windings from a Δ connection to a Y connection during starting, what is the maximum starting current that the controller must be designed to handle?
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd