What final temperature will be reached by the water

Assignment Help Chemical Engineering
Reference no: EM131158889

Hydrogen gives off 120. J/g of energy when burned in oxygen, and methane gives off 50. J/g under the same circumstances. If a mixture of 5.0 g of hydrogen and 10. g of methane is burned, and the heat released is transferred to 50.0 g of water at 25.0C, what final temperature will be reached by the water?

Reference no: EM131158889

Questions Cloud

Internet network applications as unattractive to novices : Janet Abbate describes 1980s Internet network applications as unattractive to novices. How did the World Wide Web change that in the 1990s?
What do people say with their bodies : Station yourself somewhere (library, cafeteria, etc.) and observe the nonverbal communication that occurs. What do people say with their bodies? What messages are implicit in vocal expressions, clothes, make-up and so on? Take notes on five of ..
Foreign debts of the philippines and its origin : Give your opinion regarding the inflating foreign debts of the Philippines and its origin.
What is the capitalized cost of each of ogdens land : What is the capitalized cost of each of Ogden's land. land improvements. and building and Prepare a schedule of depreciation expense per year for the van under the three depreciation methods.
What final temperature will be reached by the water : Hydrogen gives off 120. J/g of energy when burned in oxygen, and methane gives off 50. J/g under the same circumstances. If a mixture of 5.0 g of hydrogen and 10. g of methane is burned, and the heat released is transferred to 50.0 g of water at 2..
United states finally abandon policy : Can an history tutor help me on this question about one page please. 1.) Why did the United States finally abandon its policy of neutrality and declare war on Germany in 1917?
Prepare a srs for the antarctica life support facility : Prepare a Software Requirements Specification for the Antarctica Life Support Facility. Shelters shall be provided for necessary maintenance and repair to the drilling and coring -what are the necessary maintenance types?
What is your mission and who is your customer : Organization Theory & Behavior (Goldman Sachs Presentation)- What is your mission? Who is your customer? What does your customer value
Inevitable catalyst for the eventual war : Question: Was The Townshend Act an inevitable catalyst for the eventual war?

Reviews

Write a Review

Chemical Engineering Questions & Answers

  Commonly used by environmental chemists

Calculate the molarity of each of the following aqueous solutions. a. 5.0 ppb Hg in H2O b. 1.0 ppb CHCl3 in H2O c. 10.0 ppm As in H2O d. 0.10 ppm DDT (C14H9Cl5) in H2O.

  Estimate the weight of this person''s right leg

Suppose a 125-lb person lies supine on a board resting on knife edges spaced 72 in. apart (Fig. 5.7). Assume that the center of gravity of the lower limb is located through the center line of the limb and 1.5 in. above the knee cap. Estimate the w..

  Find the transfer rate if the time constant equals 27 103 s

Two compartments, with equal volumes of 0:0572 cm3, are separated by a thin membrane. If all of the solute is initially dumped into one compartment, then find the transfer rate if the time constant equals 27 103 s.

  Compute the resultant force and its location

The force plate in Figure 4.9 is 70 cm by 70 cm square. At a particular instant of the gait cycle each transducer reads F1 ¼ 210 N, F2 ¼ 220 N, F3 ¼ 150 N, and F4 ¼ 180 N. Compute the resultant force and its location.

  Reasonable value for the specific heat of coffee

A 25 wt% solution of coffee in water at 70°F is spray dried to a final moisture content of 5% (dry basis) with air that enters at 450°F and 1 atm with a humidity of 0.01 lb/lb (dry basis) and exits at 200°F. Assuming a reasonable value for the spe..

  Find the kþ cytoplasm concentration

The resting potential of the membrane is 52 mV at room temperature. Find the Kþ cytoplasm concentration.

  Calculate the number of theoretical plates required

The reflux ratio is set at 4.0:1. Calculate the kg mol/h distillate D and bottoms W and their compositions. Also, calculate the number of theoretical plates required.

  Materials of construction for the tanks

Plain carbon steel would be a suitable material for the tanks, but it is essential that the polymer does not become contaminated with iron in storage. Suggest some alternative materials of construction for the tanks.

  Approximate percentages of the microconstituents

For parts (a), (c), (d), (f), and (h) of Problem 10.20, determine the approximate percentages of the microconstituents that form. (a) Rapidly cool to 250(C (480(F), hold for 103 s, then quench to room temperature.

  Find a value for the viscosity of honey

For honey, which is Newtonian, the plot should be linear with the slope equal to the viscosity. Calculate the viscosity (or let Excel do it for you). Do a little Google or literature searching and see if you can find a value for the viscosity of h..

  Find the induced emf across the coil

Calculate the average mechanical torque needed to turn the coil and generate power for the resistor. Identify the action of the device as that of a motor or a generator.

  Find the rated and maximum torques

Find the rated and maximum torques.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd