What are the volumetric flow rates of the two outlet streams

Assignment Help Civil Engineering
Reference no: EM13300094

A permeation membrane separates an inlet air stream (79 mol% N2, 21 mol% O2) into a permeate stream and a reject stream. The inlet stream conditions are 293K, 0.5 MPa and 2 mol/min; the conditions for both outlet streams are 293 K and 0.1 MPa. If the permeate stream is 50 mol% O2, and the reject stream is 13 mol% O2, what are the volumetric flow rates of the two outlet streams?

Reference no: EM13300094

Questions Cloud

Calculate the total cost in usd : Without a forward contract, what is the dollar-cost of the shipment if the spot exchange rate at the time of purchase is $0.75?
Explain mixtures has the lower ph : Which of the following mixtures has the lower pH. A) Equal volumes of 0.10M HClO4 and 0.10M NaOH. B) Equal volumes of 0.10M HClO4 and 0.10M NH3.
Graphical demand and supply analysis : Graphical demand and supply analysis, explain the impact on price and quantity in the market for petrol if oil production is disrupted.
What is the unknown wavelength : Two parallel slits are illuminated by light composed of two wavelengths. One wavelength is ?A = 560nm. The other wavelength is ?B, What is the unknown wavelength
What are the volumetric flow rates of the two outlet streams : A permeation membrane separates an inlet air stream (79 mol% N2, 21 mol% O2) into a permeate stream and a reject stream. The inlet stream conditions are 293K, 0.5 MPa and 2 mol/min; the conditions for both outlet streams are 293 K and 0.1 MPa.
How large is the east component of this second path : A person walks 34.0? north of east for 4.10 km. Another person walks due north and due east to arrive at the same location. How large is the east component of this second path?
Use the afn equation to forecast baxters additional funds : The after tax profit margin is forcasted to be 5%, and the forecasted patour ratio is 70%. Use the AFN equation to forecast Baxter's additional funds needed for the coming year.
Determine the maximum in-plane shear stress on the wall : a). Determine the state of stresses in the walls and indicate these stresses (including arrows to denote the direction of the stresses) on the element below. b). Then, determine the maximum in-plane shear stress on the wall of the pipe using Mohr's..
Explain the cacl2 is purchased in the hydrated form : The CaCl2 is purchased in the hydrated form. it contains one mole of water for each mole of compound, NaCO3 * H2O, and had a formula weight of 124.01 g/mol.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Consolidated-drained triaxial shear test

A consolidated-drained triaxial shear test on a normally consolidated clay yielded a drained friction angle of 28 degrees. If the confining pressure during the test was 15 psi, what was the major principal stress at failure.

  Determine what is the max length of the slotted region

a rectangular bar of length l has a slot in the middle half of its length. the bar has width b, thickness t, and modulus of elasticity E. the slot has a width b/4. the stress in the middle region is 24000 psi, the length is 30 in, andthe modulus o..

  Calculating the principle of shoring system

How to calculate the principle of shoring system in formwork analysis when the secondly floor upper has been poured?

  What percentage savings is achieved by replacing single pane

The size of the house is 28ftx40ftx10ft. For simplicity, assume the roof is flat, covered with 1-in plywood plus asbestos shingles and has 3 1/2 in of fiberglass insulation. There is a wood subfloor (25/32 in) in the attic and a ahrdwood floor (3/..

  Horizontal distance between the points

A runs slope a distance of 156.777 m from one point to another point at a rate of +1.5%. What is the corresponding horizontal distance between the points?

  Determine the required thickness of the pipe wall

Determine the required thickness of the pipe wall if the operational pressure head (pressure head in the pipe under regular flow conditions) is 40 m and if the flow control valve on the downstream end closes suddenly, developing a water hammer in ..

  Calculate by what factor the mass of propane has increased

A typical propane tank that we use for barbeque initially contains a pressure of 10 psi. The pressure is low, so we take it to the local store to fill the tank with more propane. After filling,the pressure is 100 psi.

  Vehicle delay due to queuing

Vehicles begin to arrive at a toll booth at 850 am with an arrival rate of x(t) = 4.1 + .01t (with t in min and x(t) in veh /min.) The toll booth opens at 9am and processes vehicles at a rate of 12 per minute throughout the day. Assuming D/D/1 que..

  Waterline of center of gravity

The ship has a total weight of 155,000 tons, length = 1,600 feet and a beam = 150 feet (assume that it is the shape of a rectangular box). Calculate the height above the waterline of its center of Gravity (G).

  Find corresponding racing speed and drag on the car

A one tenth scale model of a soap box derby car is tested in a wind tunnel. The air speed in the wind tunnel is 70m/s, the air drag on the model car is 240 N, and the air temperature and pressure are identical to those expected

  What is the benzene concentration at the dwtpat steady state

An industry is illegally dischargingbenzeneinto a river. The concentration in the river atthe point of discharge is 0.2mg/L. A drinking water treatment plant (DWTP) is located 1.5km downstream. The watervelocity in the riveris 0.35km/day.

  Explain in detail different types of surveys

what are the main points which create necessity of new railway line? explain in detail different types of surveys conducted in railway work.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd