What are the rotational velocity in rpm and linear velocitie

Assignment Help Civil Engineering
Reference no: EM13563791

One form of which consists of three equal weights joined by equal length ropes. The gaucho holds on to one weight spinning the bolas overhead. When the bolas is cast the weights cause the configuration to change. A typical bolas consists of three one pound weights joined by three 2 feet 4 inch lengths of rope. Before casting the weights have a velocity of 60 RPM. What are the rotational velocity in RPM and linear velocities of the weights after throwing? If the radius of the weight is small compared to the radius of the motion, the mass moment of a weight is I = md2 where d is the distance from rotation center to weight

Reference no: EM13563791

Questions Cloud

What is the reason for the relatively high strength of wood : The de-carburization of a steel can also be described by the error fuction. Starting with the equation, (cx-c0)/(sc-c0) = 1-erf(x/(2*(sqrt(Dt)))), and taking cs=0 derive an expression to describe the concentration profile of carbon as it diffuses out..
Under what condition will both the soil have the same weight : A box of mass M=500 kg hangs by a rope from a beam with dimensions a=2.0 m and b=3.0 m. The beam has mass m=85 kg. Find the tension T_c in the cable and the magnitude of the net force F exerted on the beam by the hinge. (Engineering firms usually nee..
Find the critical value of the test statistic : A new concrete mix is being designed to provide adequate compressive strength for concrete blocks. The specification for a particular application calls for the blocks to have a mean compressive strength greater than 1350 kPa. A sample of 100 blocks i..
Draw the bending moment diagram for the beam abcd subjected : Draw the bending moment diagram for the beam ABCD subjected to the loading obtained from 2). (The location and magnitude of the maximum bending moment must be calculated)
What are the rotational velocity in rpm and linear velocitie : One form of which consists of three equal weights joined by equal length ropes. The gaucho holds on to one weight spinning the bolas overhead. When the bolas is cast the weights cause the configuration to change
What is the uniform deterministic arrival rate : A ferryboat queuing lane holds 40 vehicles. If vehicles are processed (tolls collected) at a uniform deterministic rate of 5 vehicles per minute and processing begins when the lane reaches capacity
How much power is required to maintain straight and level : If the aircraft is flying at 8,000 ft above the ground and the engine suddenly quits, how far could the aircraft glide before reaching the ground?
Determine the actual concentration for both pollutants : An industrial off gas steam must be treated for both particulates and SOx. The gas is at 1500 degrees F and 1.5 atm of pressure containing 80 mg/cubis meter of particulates and 25 mg/cubic meter of SOx. A two unit system is bring considered consistin..
Design a cyclone that has a collection efficiency between 80 : Design a cyclone that has a collection efficiency between 80% and 85% (use parcticle size distribution given below). you must assume a dpc of 4.2 microns,an inlet gas velocity of 25 m/s and a K of 15.The unit must handle 20,000 cfm of contaminated ..

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the foundation soils allowable bearing

A square footing 2 meters by 2 meters is to be constructed 1.22 meters below the ground surface. The groundwater table is located 1.82 meters below the ground surface. The subsoil consists of a uniform, medium dense, cohesionless soil with the follow..

  How much will the purchaser make on the investment

A 12%, $50,000 bond is offered for sale at $45,000. If the bond interest is payable monthly and the bond matures in 20 years, what nominal effective rates of return per year will the purchaser make on the investment

  Construction of the embankment

Pore water pressure is to be observed during the construction of the embankment. Calculate the pore water pressure which must not be exceeded at any point in the clay layer 9 m below the surface of the embankment to ensure a shear strength of 100 ..

  What amount of tension do you need to apply not to have any

You are using that tape to measure the distance between two pointswhere the tapes are supported at the ends only. The temperature ofthe day is 68oF. What amount of tension do you need to apply not tohave any corrections in the tape measurement?

  Determine bod reaction rate constant of municipal wastewater

If the BOD5 of a municipal wastewater is 310 mg/L and the BOD U is 340 mg/L, determine the BOD reaction rate constant (base e). What would be the 3 day 30°C BOD Assume, temperature coefficient = 1.047.

  How many extractions are required to decreases concentration

How many extractions are required to decrease the concentration of phenol below 100 mg/L in a wastewater containing 2000 mg/L of phenol if an ether-to-watewater ratio of 0.2 by volume is used in each extraction

  How long will it take for the pce to reach the well

The water is pumped out of the aquifer at a rate of 2000 gpd, treat it with activated carbon and then put it back into the aquifer. At the flow rate how long until al the PCE is removed, assume carbon removed 100% of the PCE (ans. 54 days)

  What is the percent change from 10m to the surface

What is the percent change from 10m to the surface. Use absolute pressure and assume standard atmospheric conditions. Would the answer change with a different system of units.

  Does the steel have adequate charpy v notch fracture tough

A Charpy V Notch test was conducted for an ASTM A572 Grade 50 bridge steel. the average values of the test results at four different test temperatires were found to be 10ft.lb -(-50 F) 15 ft.lb- 0F 40 ft.lb- 40F 60 ft.lb-100 F

  List some of the advantages and disadvantages of rectangular

List some of the advantages and disadvantages of rectangular primary sedimentation tanks over circular sedimentation tanks which must be considered prior to the selection

  Use a numerical method to estimate the excess pore pressure

At the site of a large scale land reclamation project 2 m of sand overlie a silty clay layer 5 m thick, which overlies highly fractured permeable rock.

  Determine the additional force that will be required

A two-axle truck being driven on a flat and straight section of a highway at a speed of 65 mph reaches a curved section of the highway with a grade of 5% and a radius of 1,500ft.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd