What are the power developed and the heat rejected

Assignment Help Chemical Engineering
Reference no: EM131172233

A Carnot engine receives 250 kW of heat from a heat-source reservoir at 798.15 K (525°C) and rejects heat to a heat-sink reservoir at 323.15 K (50°C). What are the power developed and the heat rejected?

Reference no: EM131172233

Questions Cloud

What is the temperature of the gases leaving the reactor : If the gases enter the reactor at 348.15 K (75"C), if conversion is 80%, if no side reactions occur, and if the reactor operates adiabatically, what is the temperature of the gases leaving the reactor? Assume ideal gases.
Evaluate the current technology and scm systems : Evaluate the current technology and SCM systems utilized by e-business. Research potential new markets or suppliers that can be used to grow the e-business.
Will the buyer succeed in recovering the excess : A shipbuilder had contracted to build a tanker for North Ocean Tankers. The contract was in US dollars and didn't contain any provisions for currency fluctuations. Will the buyer succeed in recovering the excess
How should the stadium or arena be financed : How should the stadium / arena be financed? What is your justification? Why did you choose this option over other options?
What are the power developed and the heat rejected : A Carnot engine receives 250 kW of heat from a heat-source reservoir at 798.15 K (525°C) and rejects heat to a heat-sink reservoir at 323.15 K (50°C). What are the power developed and the heat rejected?
How does the u.s. rank in terms of its physical inactivity : Which countries have problems with physical inactivity? How does the U.S. rank in terms of its physical inactivity?
What volumetric flow rate of fuel gas is required : Of the entering methane, 70% burns to carbon dioxide and 30% burns to carbon monoxide. What volumetric flow rate of fuel gas is required if there are no heat losses to the surroundings?
What temperature does the flue gas leave the furnace : If 800 GJ per kmol of fuel is transferred as heat to boiler tubes, at what temperature does the flue gas leave the furnace? Assume complete combustion of the fuel.
Evaluate the formal performance appraisal systems : 201630 HRM502 Additional Assessment Essay. Critically evaluate the proposition that formal performance appraisal systems should be abandoned by organizations

Reviews

Write a Review

Chemical Engineering Questions & Answers

  Develop a project plan and schedule of tasks for engineer

Develop a project plan and schedule of tasks for each engineer. Be sure to allow sufficient time for equipment sizing, costing, and optimization. What intermediate deliverables would you specify to ensure that the project stays on track?

  Ideal gas law air at 4mpa and 3000c enters a will

air at 4mpa and 3000c enters a will insulated turbine operating at steady state with negligible velocity. the air

  Find one possible logic circuit to realize the output

For the segment Y3 to be turned on, develop the logic expression and find one possible logic circuit to realize the output in each case.

  Estimate the amount of adsorbent needed

The activated carbon adsorbent has average bulk density 120 kg/m3 and heat capacity 0.7 J/g.°C. The solvent flammability limits in air are 2.5 to 12.0 vol% at 293 K and 1.2 to 16.0 vol% at 363 K.

  What is the temperature and phase in tank

A closed tank, 1 m3 in volume is filled with water at 1 bar 80 °C. A second identical tank contains 20 kg of steam at 20 bar. What is the mass of water in tank 1?

  Transfer coefficient from a free water surface

Mass transfer coefficient from a free water surface to an adjacent moving air stream has been found to be 0.015 kg/m2-s. Estimate the rate of evaporation from a surface of 1 m2 at a temperature of 28 oc into an air..

  Who should make the decision

If the family of a patient in the intensive care unit submits the individual's living will document, should it be honored immediately or should there be a discussion between physicians and the family? Who should make the decision? Why?

  Find the maximum kva rating as an autotransformer

Draw a schematic connection diagram as an autotransformer.

  Evaluate the frequency for each of the waveforms

Three waveforms seen on an oscilloscope are shown in Figure P1.4.7. If the horizontal scale is set to 50 ms per division (500 ms for the entire screen width), and the vertical scale is set to 5 mV per division (±25 mV for the entire screen height ..

  Determining the standard normal distribution

The scaling factor k must be such that the total probability is one. Therefore, we have k = 1/36. The table shows one instance where x + y >5, which is x = 3, y = 3. The probability is p = 9/36 = 1/4.

  How is such a rom described

Develop a two-dimensional addressing system using a 6-to-64 decoder, a 64-word×128- bit matrix, and 16-input multiplexers. How many gates would such a system require?

  The concentration of oxygen at two places

Question - 1 In an oxygen -nitrogen mixture at 10 atmosphere and 25 oc , the concentration of oxygen at two places 0.2 cm apart are 10 and 20 volume percent respectively. The rate of diffusion of oxygen expressed as g /cm2 -hr for the case of unic..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd