What are the heat addition rate in the combuster and the

Reference no: EM13535623

A “Cold Air-Standard Brayton cycle” gas-turbine power plant delivers a net power output of 60 MW to an electric generator. The compressor intake temperature is 300 K and the maximum temperature in the cycle is 1200 K. The minimum pressure in the cycle is fixed at 100 kPa. If compressor pressure ratio is set at 11 to 1, calculate the plant efficiency and the power output of the turbine. What are the heat addition rate in the combuster and the fraction of the turbine output is required to drive the compressor?

Reference no: EM13535623

Questions Cloud

What must the hydraulic detention time be in the aeration : Although primary and secondary sedimentation is responsible for the removal of some BOD, you will design a bioreactor which removes 85% of BOD entering the plant using an activated sludge bioreactor. Use the following values: Influent (to bioreactor)..

What are alternative treatment option for the removal of edc : What are alternative treatment options for the removal of EDCs in tertiary treatment? Be sure to justify any alternative treatment method you propose.

A water pump can generate a pressure diference : A water pump can generate a pressure diference ΔP (psi) given by ΔP=145-0.1Q2, Q is the flow rate in ft3/s. It suplies a pipe of diameter 20", roughness of .5 inches and length of 2500 ft.

Determine the net power delivered and the cycle efficiency : Determine the net power delivered and the cycle efficiency. What is the percent increase in the efficiency compared to an otherwise identical system with no regeneration. Assume “cold air-standard cycle” for both systems above.

What are the heat addition rate in the combuster and the : A “Cold Air-Standard Brayton cycle” gas-turbine power plant delivers a net power output of 60 MW to an electric generator. The compressor intake temperature is 300 K and the maximum temperature in the cycle is 1200 K.

What is the diameter of the bubble before it reaches : Listed on cramster as ask. There is a car driving through water. Velocity is 12mph. Find h (max water depth) that will alow car to pass. List all assumption and calculations is the problem statement.

Calculate the minimum required cross-sectional area : The moduli of elasticity of plain concrete and steal are 25 GPa and 207GPa respectively, and the corss-sectionial area of steel is 2% of that of the reinforced concrete.

Calculate the detention time in hours horizontal velocity : Two rectangular clarifiers(sedimentation basins), each 30 ft long, 15 ft wide, and 10ft deep, settle a combinedtotal of 0.40 mgd following alum coagulation. The effluent channelshave a total weir length of 60ft in each basin

The angle theta which the 6-lb. uniform rod makes with the v : A 5-lb force is applied to the center of the roller at A, causing the assembly to roll. If the roller has negligible mass, determine (a) the angle theta which the 6-lb. uniform rod makes with the vertical during the roll, and

User Account

All Pages