User Account

All Pages

To what rate of corrosion in mm per yr dose the correspond

Assignment Help Civil Engineering
Reference no: EM13314021

A thick steel sheet of area 440cm3 is exposed to air near the ocean. After a one-year period it was found to experience a weight loss of 880g due to corrosion. To what rate of corrosion in mm/yr dose this correspond

Reference no: EM13314021

Questions Cloud

Explain the hcl and nh3 to meet in the glass tube : The mean velocities of HCl gas and NH3 gas at 25 degrees Celsius are 450m/s and 660m/s respectively. With these speeds in mind, briefly explain why so much time was required for the HCl and NH3 to meet in the glass tube
Estimate the time of submersion in years of the plate : Apiece of corroded steel plate was found in a submerged ocean vessel. it was estimated that the original area of the plate was 62.5cm 2 and approximately 2.8k had corroded away during the submersion.
What is the weight of the block : A 10 kg block of ice slides along a frictionless surface that is inclined at a 60 degree angle with the horizontal. What is the weight of the block
Find the speed of the stone just before it hits the ground : you throw a stone upward with an intial speed of 5.8m/s from a third-story office window. Find the speed of the stone just before it hits the ground
To what rate of corrosion in mm per yr dose the correspond : A thick steel sheet of area 440cm3 is exposed to air near the ocean. After a one-year period it was found to experience a weight loss of 880g due to corrosion. To what rate of corrosion in mm/yr dose this correspond
Explain molecular ions of about equal intensity : Provide a structure for the following compound: EI mass spectrum: two molecular ions of about equal intensity at m/z = 180 and 182; IR: 1740 cm-1; 1H NMR: ? 1.30 (3H, t J = 7 Hz); ? 1.80 (3H, d, J = 7 Hz); ? 4.23 (2H, q, J = 7 Hz); ? 4.37 (1H, q, ..
Calculate the temperature of the liquid : The length of the mercury column at the ice point and steam point are 5.0 cm and 40.0cm respectively. What is the temperature of the liquid
How to estimate the time of submersion in years : Apiece of corroded steel plate was found in a submerged ocean vessel. it was estimated that the original area of the plate was 62.5cm 2 and approximately 2.8k had corroded away during the submersion.
What is the magnitude of the frictional force : Bob walks up to the crate and begins pushing with 200N of force. What is the magnitude of the frictional force now

Reviews

Write a Review

Civil Engineering Questions & Answers

  What depth of aggregate is needed if angle theta is 40degree

A 2000-lb wheel load is to be supported by aggregate over soil with a maximum bearing pressure of 1000 lb/sqft. What depth of aggregate is needed if the angle theta is 40 degrees

  Find shear stress on each bolt and bearing stress on the bar

Due to an error, the length L shown was 1.795 m instead of 1.80 m, thus there is a gap of 0.5 cm, which makes it difficult to bolt the bar on the structure. The engineer suggests the bar is heated up by - Delta in order to close the gap.

  What is tension in the cable connecting the boat to the pier

What is the tension in the cable connecting the boat to the pier Angle of spray 50 degrees off horizontal axis and is spraying toward the pier and pushing the boat away from the pier.

  Determine the minimum height on the wall from hose

Determine the minimum height on the wall to which the firefighter can project water from the hose, so that the water strikes the wall horizontally. The speed of the water at the nozzle is Vc=48ft/s.

  Find bod reaction rate constant of a municipal waste water

If the BOD5 of a municipal wastewater is 310 mg/L and the BODU is 340 mg/L, determine the BOD reaction rate constant (base e). What would be the 3 day 30°C BOD Assume, temperature coefficient = 1.047.

  Select the sentence that is punctuated correctly

Select the sentence that is punctuated correctly.

  Length of contracted rectangular weir

A trapezoidal canal 6m wide at the bottom and having a side slope of 1V:2H carries water with a mean velocity of 1.0m/s to a depth of 60cm. What length of contracted rectangular weir 1.0m high should be placed at the middle of the canal to make th..

  Determine the total resultant force

in inclined circular gate with water on one side shown in the figure. determine the total resultant force acting on the gate and the total location of center pressure.

  Create a vba function that will return the root of function

Create a VBA function that will return the root of the function e-x -x = 0 using the Newton-Raphson method. The input parameter for the function should be the initial guess for the root. Turn in your code for the VBA function.

  Determine what is the instrumental and statistical error

During an experiment, the depth of a water flow in a flume is measured five times by using a ruler with 1/16-in division. The results from these measurements are 4.88 in, 5.06 in, 5.03 in, 5.13 in, 4.94 in. What is the instrumental error and what ..

  Compute the load shown on the hook load indicator

A rig accelerates a load of 200000 lbf from zero to 60 ft/min in 5 seconds. compute the load shown on the hook load indicator.

  Design the pins so that the ledge can support doug

Design the pins so that the ledge can support Doug and Jeremy and eight others on each side of the building. Assume each person weighs 200 lbs.Pin properties: Ultimate shear strength = 100 lb/in^2

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd