Estimate the time of submersion in years of the plate

Assignment Help Civil Engineering
Reference no: EM13314024

Apiece of corroded steel plate was found in a submerged ocean vessel. it was estimated that the original area of the plate was 62.5cm 2 and approximately 2.8k had corroded away during the submersion. Assuming a corrosion penetration rate of 5.1mm/yr for this alloy in seawater. Estimate the time of submersion in years. The density of steel is 7.9g/cm3

Reference no: EM13314024

Questions Cloud

What was your reaction time : You are driving down the road at 60 km/hr when you see a chicken dash out onto the road 23.3 m in front of you. What was your reaction time
What force does friction exerts on the skater : A 68-kg skater moving initially at 2.4 m/s on rough horizontal surface comes to rest uniformly in 3.52 s due to friction. What force does friction exerts on the skater
Use an x, y translation transform : Several multi exposure image sequences (of three images) will be released on the day the assignment is marked.
Explain the hcl and nh3 to meet in the glass tube : The mean velocities of HCl gas and NH3 gas at 25 degrees Celsius are 450m/s and 660m/s respectively. With these speeds in mind, briefly explain why so much time was required for the HCl and NH3 to meet in the glass tube
Estimate the time of submersion in years of the plate : Apiece of corroded steel plate was found in a submerged ocean vessel. it was estimated that the original area of the plate was 62.5cm 2 and approximately 2.8k had corroded away during the submersion.
What is the weight of the block : A 10 kg block of ice slides along a frictionless surface that is inclined at a 60 degree angle with the horizontal. What is the weight of the block
Find the speed of the stone just before it hits the ground : you throw a stone upward with an intial speed of 5.8m/s from a third-story office window. Find the speed of the stone just before it hits the ground
To what rate of corrosion in mm per yr dose the correspond : A thick steel sheet of area 440cm3 is exposed to air near the ocean. After a one-year period it was found to experience a weight loss of 880g due to corrosion. To what rate of corrosion in mm/yr dose this correspond
Explain molecular ions of about equal intensity : Provide a structure for the following compound: EI mass spectrum: two molecular ions of about equal intensity at m/z = 180 and 182; IR: 1740 cm-1; 1H NMR: ? 1.30 (3H, t J = 7 Hz); ? 1.80 (3H, d, J = 7 Hz); ? 4.23 (2H, q, J = 7 Hz); ? 4.37 (1H, q, ..

Reviews

Write a Review

Civil Engineering Questions & Answers

  Draw a mohrs circle and solve for max shear forces

You are given a mohrs circle with 10 kPa (assume positve since geotech question) in compression for sigmaz and 2 kPa (+ counterclockwise) force for shear z. This force lies on a plane 15 degrees CW.

  How many short tons of coal are required

How many short tons of coal are required by this plant per year, assuming it operates continuously? If 10% of the coal mass remains as residual ash, how many tons will develop in the ash pile over 25 years?

  Determine at what time does the minimum volume occur

The inflow to a small reservoir during a storm may be described by the equations Q=1000(1-e^-kt) where Q= flow in cfs k= runoff rate = 1.0 per hour t = time in hours The outflow through the dam gates is held constant at 800 cfs.

  What are the velocities of both just before and after impact

What are the velocities of both just before impact and just after impact. There is a distance of 5m between the vehicles prior to the winch being turned on.

  Determine the maximum load p that can be applied

The 25mm thick strut shown below is glued to the horizontal member along surface AB. The glue can resist a shear stress of 600 kPa before failing, and the horizontal member can resist a normal stress of 2000 kPa before a bearing failure occurs.

  Designing the tangent vertical curve

Due to a street crossing a roadway, the elevation of the roadway at station 3 +413.760 must be at 129.388 m. Design the curve?

  How far downstream would you establish barricades

The fire department proposes to approach the truck from the upstream side and heavily spray the truck with water to prevent an explosion. Will this help to reduce the chlorine concentration downstream?

  What is the effective stree at the base of the aquifer

THE WATER TABLE OF A SATURATED , UNCONFINED AQUIFER COINCIDES WITH THE LAND SURFACE. THE AQUIFER IS 52 FT THICK AND THE MATERIAL HAS A UNIT WET WEIGHT OF 135 LB/FT^3.

  Draw the bending moment diagram and shear force diagram

consuder a simply suppurted beam of length 10 feet with concentrated load of 1000lb at the centre of the beam. Draw the bending moment diagram and shear force diagram

  Find the net force required to hold the bend in place

A 1m diameter pipe bend is carrying water with a steady flow rate of 2 m3/s. The bend has an angle of 90o and lies in a horizontal plane. The volume of water in the bend is 1.5 m3 and the empty weight of the bend is 4 kN.

  Determine what is steady state effluent concentration of si

Water flows into and out of a 5 liter tank at a rate of 1 L/min. Within the tank, the mineral apatite is dissolving at a rate of 3x10^-10 moles of Si per m^2 per sec. If the tank contains 10g of the apatite with a specific surface area of 2 m^2/g,

  Calculate deformation of truncated equilateral steel pyramid

Calculate deformation of the truncated equilateral triangular steel pyramid. The pyramid has the height h of 156mm truncated at the top by 2mm and the base side s of 127mm.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd