The plus sight and minus sight distances were kept approx

Assignment Help Civil Engineering
Reference no: EM13559365

A differential leveling loop began and closed on BM bridge (elevation 103.895m). The plus sight and minus sight distances were kept approximately equal. Readings (in meters) listed in order taken are 1.023(+s) on BM bridge, 1.208 (-s) and 0.843 (+s) on TP1, 0.685 (-s) and 0.982 (+s) on BM X, 0.944 (-s) 1.864 (+s) on TP2, and 1.879 (-s) on BM bridge. Prepare, check, and adjust the notes.

Reference no: EM13559365

Questions Cloud

What is the final pressure in the device : A .2kg mass of argon gas fills a .05m^3 piston-cylinder volume at a pressure of 400 kPa absolute. The piston induced pressure is changed until the volume expands to twice its original value, while the temperature remains constant.
What is the velocity of the water at the exit for maximum : A suction device is being designed based on the Venturi principle to life objects in submerged water. The operating water temperature is 50C. The suction cup is located 1.3 m below the water surface, and the Venturi throat is located
Find the final temperature : A horizontal water jet impinges against a vertical flat plate at 25 ft/s and splashes off the sides in the vertical plane. If a horizontal force of 350 lbf is required to hold the plate against the water stream, determine the volume flow rate of the ..
Determine the maximum horizontal distance that a projectile : Determine the maximum horizontal distance that a projectile will have at a height of 60 m above the orgin if it is fired at an angle at 70 degrees from the horizontal with a velocity of 50 m/s
The plus sight and minus sight distances were kept approx : A differential leveling loop began and closed on BM bridge (elevation 103.895m). The plus sight and minus sight distances were kept approximately equal
How many extractions are required to decrease : Phenol is approximately 12 times more soluble in 1 volume of isopropyl ether than it is in 1 volume of water. How many extractions are required to decrease the concentration of phenol below 100 mg/L
What mass of pac must be placed in a contact basin : Toluene has contaminated a city's drinking-water supply. An activated carbon system has been constructed so toluene concentrations are treated to below specified regulatory levels. If the toluene concentration in the water supply is 1,000 ppb
How far did the piston move use interpolation : A piston cylinder is filled with .85 kg of refrigerant-134a at -10 degrees Celsius. The piston moves freely, and has a mass of of 12 kg and a diameter of 25 cm. Heat is added to the closed system (the refrigerant) until the temperature rises to 15 de..
Compute the design strengths of a rectangular beam with : Compute the design strengths of a rectangular beam with bw=15 in, d = 36 in, d'=2.5 in, fy= 60ksi, fc'=4ksi, and at the top of the beam are 4 #8 bars, the bottom has two rows of 4 #10 beams

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the friction force exerted on the plate at a

The frame is supported in part by normal and friction forces between the wall and the plate at A. Determine the friction force exerted on the plate at A. Also determine the minimum required coefficient of friction at A for the frame to remain in e..

  Determine the components of reaction at hinge a

The 90lb door has its center of gravity at G. A)Determine the components of reaction at hinge A if hinge B resists only forces in the x and y directions and A resists forces in the x,y,z directions.

  Specify the amount of convective acceleration

shaped nozzle such that the velocity along the center line of the flow increased from 1.5 m / s to 15 m / s at a distance of 37.5 m. specify the amount of convective acceleration at the beginning and end of the range.

  Determine the coefficient of statics friction of hawser

Determine the (a) the coefficient of statics friction between the hawser and the bollard. (b) the number of times the hawser should be wrapped around the bollard if a 20000 pound force is to be resisted by the same 80 pound force

  How many extractions are required to decrease

Phenol is approximately 12 times more soluble in 1 volume of isopropyl ether than it is in 1 volume of water. How many extractions are required to decrease the concentration of phenol below 100 mg/L

  Determine the design hourly volume for the road

Determine the design hourly volume for the road below, recommend the K factor first.

  What rate of perspiration would be needed to maintain a

Considere a person who consumes 2100 kcal par day, of which 2000 kcal is converted thermal energy.( the remaining 100 kcal is used to do work on the environment.) The person has a surface area of 1.8 m² and is dressed in a bathing suit.

  Find who has positive breathalyzer test is actually driving

a police officer stops a speeding driver on saturday nigt and gives hima breathalzer test. the test shows that his estimated blood alcohol content is above .08 g/dl, and this is considered evidence of driving while intoxicated

  Determine the maximum and minimum stress intensities

Determine the maximum and minimum stress intensities in the section.

  Define what is the federal express philosophy toward quality

What is the Federal Express philosophy toward quality? What specific elements/actions has FedEx implemented in its quality improvement history?

  Determine the most economical design pipe size and number

Determine the most economical design (i.e. pipe size and number and location of pumps). Hint: Vary your pipe diameter and consider pumps in series.

  What is the total deformation in square steel hanger

What is the total deformation in a 15' 2'' square steel hanger that supports a 36000 pound load

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd