Specify the horsepwoer of the fan motor

Assignment Help Civil Engineering
Reference no: EM13561491

A fixed-bed carbon adsorption system consisting of two 3-foot-deep beds containing 6 x 16 mesh carbon operates at a superficial gas velocity of 60 ft/min. Specify the horsepwoer of the fan motor for 15,000-cfm system if the total pressure drop across the system excluding the pressure drop across the bed is 5 inches H20.

Reference no: EM13561491

Questions Cloud

What is the minimum amount of carbon needed : You are assined the task of process design for a fixed-bed carbon adsorber system. You are given the following data: the inlet airstream flows at 5000 acfm (at 95 degrees F and 1 atm) and contains .2% n-pentane by volume; the proper operating carbon ..
Estimate the bed dimensions : Estimate how much carbon (in pounds) must be purcahsed for a typical 2-bed carbon adsorption system to treat 5000 cfm of air at 95 degrees F and 1 atm. The air contains 600 ppm of styrene.
Discuss all the advantages disadvantages and considerations : A flocculation/sedimentation combination basin in a conventional drinking water treatment plant is to be constructed of cast-in-place reinforced concrete. The horizontal flow rectangular basin will be located in New Jersey, USA
Find angle cde : At A, Mary sighted on point B and measured angle BAE by turning an angle to the right. The angle BAE is 113º42’00”. Then, they measured distance AB as 300.11 ft.
Specify the horsepwoer of the fan motor : A fixed-bed carbon adsorption system consisting of two 3-foot-deep beds containing 6 x 16 mesh carbon operates at a superficial gas velocity of 60 ft/min
Compare two conflict resolution techniques : Compare two conflict resolution techniques. Explain the advantages and disadvantages as they relate to work situations, and provide an actual example of one method in action
Find how far up the incline do the monkey and sled move : In a circus performance, a monkey is strapped to a sled andboth are given an initial speed of 5.0m/s up a 16.0° inclined track. How far up the incline do the monkey and sled move
Compute the velocityat various points across the channel and : The pressuregradient is 60 kPa/m, and is negative.  Compute the velocityat various points across the channel and show the results on aplot.  Assume laminar flow.
Comment on reasons for the differences between the predicted : You need to compare measured and predicted deflections for the three situations described below. Comment on reasons for the differences between the predicted and measured values. Recall that E = 69 GN/m2, rho = 2700 kg/m3, and the beam cross-section ..

Reviews

Write a Review

Civil Engineering Questions & Answers

  Actual width of the beam where tis evaluated

For a beam made of 2 materials with different moduli of elasticity,show that the shear stress formula τ =VQ/lt remains validprovided that both Q and I

  Determine for each case the ration of the total energy

Consider two cases: (1) a constant wind velocity that is twice the mean wind velocity and operating half the time; and (2) a constant wind velocity that is three times the mean wind velocity operating one-third of the time. At all other times, the wi..

  Calculate volume of thickened sludge with solids recovery

A gravity thickener receives 33.000 Lpd of wastewater sludge and increases the solids content from 3.0% to 7.0% with 90% solids recovery. Calculate the volume of thickened sludge.

  Compute the convective heat transfer coefficent

Water at a flow rate of 1 kg/s is flowing in a pipe of internal diameter 5 cm. If the inside pipe surface temperature is 90 degrees C and mean bulk water temperature is 50 degrees C

  Determine the initial acceleration of block a and b

Neglecting the mass of the pulley and the effect of friction in the pulley and between block A and the horizontal surface. Determine (a) the initial tension in the table (b) the initial acceleration of Block A (c) the initial acceleration of Block..

  Determine the cod

Determine the COD, carbonaceous BOD, and nitrogenous oxygen demand of a 100 mg/L solution of urea (N2H4CO)

  Determine the diameter of the pipe required to convey

Water at 20 °C is transported through a 200 m long wrought iron pipe with a head loss of 9.8 m. Determine the diameter of the pipe required to convey 10L/sec.

  How high did the ball roll before it momentarily stopped

A solid ball starts to roll up a hill with an initial velocity of 50m/s. The ball has a mass of 20 Kg with a 0.75 m radius. How high did the ball roll before it momentarily stopped

  Determining transformed moment of inertia

Determine the transformed moment of inertia for the beam using steel as the reference material. Express your answer in in^4 to the nearest 0.1 in^4.

  Calculate the daily discharge per 1000 feet into the river

A canal was constructed running parallel to a river 1500 ft away. Both fully penetrate a sand aquifer with a hydraulic conductivity of 1.2 ft/d. The area is subject to rainfall of 1.8 ft/y and evaporation of 1.3 ft/y.

  Determine the heights of the fluid columns for barometers

Determine the heights of the fluid columns for barometers that use the following liquids at 20 C: water, ethyl alcohol, and mercury. Why do you think mercury barometers were used in the past (before the negative health effects of mercury were know..

  What would be the concentration of pollutant in the

A lagoon with volume 1500 mg/m3 has been receivingsteady flow of non-conservative waste (reaction rake k = 0.20/day)at a rate of 125 m3/day for a long enough time to assume that steady- state conditions apply. The wasteentering the lagoon has a conce..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd