Discuss all the advantages disadvantages and considerations

Assignment Help Civil Engineering
Reference no: EM13561493

A flocculation/sedimentation combination basin in a conventional drinking water treatment plant is to be constructed of cast-in-place reinforced concrete. The horizontal flow rectangular basin will be located in New Jersey, USA. The client must decide whether or not to pay to have the basins covered with a concrete slab or,alternatively, left open. Discuss all the factors that the client should consider when deciding whether or not to cover the floc/sed basin. Discuss all the advantages, disadvantages and considerations that the client should think about. Be clear and complete so the client understands what the choices are and any ramifications of the decision.

Reference no: EM13561493

Questions Cloud

Find the acceleration of the alcohol filled shell : A thin spherical shell of mass 0.450kg and diameter 0.160 m is filled withalcohol (= 806 kg/m3). Find the acceleration of the alcohol filled shell as it rises toward the surface of the water
Compute the tax npv : Assume that the before-tax required rate of return for Deer Valley is 14%. Compute the before-tax NPV of the new lift and advise the managers of Deer Valley about whether adding the lift will be a profitable investment. Show calculations to support y..
What is the minimum amount of carbon needed : You are assined the task of process design for a fixed-bed carbon adsorber system. You are given the following data: the inlet airstream flows at 5000 acfm (at 95 degrees F and 1 atm) and contains .2% n-pentane by volume; the proper operating carbon ..
Estimate the bed dimensions : Estimate how much carbon (in pounds) must be purcahsed for a typical 2-bed carbon adsorption system to treat 5000 cfm of air at 95 degrees F and 1 atm. The air contains 600 ppm of styrene.
Discuss all the advantages disadvantages and considerations : A flocculation/sedimentation combination basin in a conventional drinking water treatment plant is to be constructed of cast-in-place reinforced concrete. The horizontal flow rectangular basin will be located in New Jersey, USA
Find angle cde : At A, Mary sighted on point B and measured angle BAE by turning an angle to the right. The angle BAE is 113º42’00”. Then, they measured distance AB as 300.11 ft.
Specify the horsepwoer of the fan motor : A fixed-bed carbon adsorption system consisting of two 3-foot-deep beds containing 6 x 16 mesh carbon operates at a superficial gas velocity of 60 ft/min
Compare two conflict resolution techniques : Compare two conflict resolution techniques. Explain the advantages and disadvantages as they relate to work situations, and provide an actual example of one method in action
Find how far up the incline do the monkey and sled move : In a circus performance, a monkey is strapped to a sled andboth are given an initial speed of 5.0m/s up a 16.0° inclined track. How far up the incline do the monkey and sled move

Reviews

Write a Review

Civil Engineering Questions & Answers

  Compute the allowable load on a column with fixed ends

Compute the allowable load on a column with fixed ends if it is 5.45 meters long and made from an S150 x 18.6(S6 x 12.5) beam. The material is ASTM A36 steel. Use the AISC formula.

  Find x-y and z coordinates of point b for radial readings

calculate the X, Y and Z coordinates of point B for radial readings taken to B from occupied station A, if the backsight azimuth at A is 25°32'48", the elevation of A = 610.098 m, and hi = 1.45 m.

  What is the rate costant base 10 assume the temperature is

For an interest rate of 12% per year compounded every 2months, determine the nominal interest rate per (a) 4 months (b) 6months, and (c) 2 years

  Estimate the particle size that will be collected with

A cyclone has been designed with an inlet width of 10cm and an inlet height of 6cm. The height of the main upper cylinder is 16cm and the height of the lower cone is 16cm. The inlet gas velocity is 16m/s and the particle density

  What is diffusion flux assuming conditions of steady state

consider the diffusion of water vapor through a polypropylene (PP) sheet 2mm thick. the pressure of H2O at the two faces are 1 kPa and 10kPa, which are maintained constant.

  Calculate aeration basin size and the wate sludge rate

A completely mixed activated-sludge plan is being designed for a wastewater flow of 3.0 mgd. The BOD of 225 mg/l is 200 mg/l soluble. The effluent soluble BOD requirement is 7 mg/l (70 percent of the total 10 mg/l).

  Determine the detention time of the first pond

Three completely mixed stabilization ponds are connected in series, and the system removes 99.998% from the total coliform count of the influent to the first pond. In stabilization ponds, coliform bacteria are removed by a first-order process

  Compute the steady-stare creep rate and stress level

If it is known that the value of the stress exponent, n, for this alloy is 8, compute the steady-stare creep rate at 1300 K and a stress level of 90 MPa.

  Assuming the entire system has reached equilibrium what is

assuming the entire system has reached equilibrium what is the distance that must be used between the inputs shown and

  Explain each of the parametersin the equation is obtained

According to barton(1974) the quality of a given rock mass can bedetermined using the equation below. explain each of the parametersin the equation is obtained.

  A dense sand has an effective friction angle of 43 and c0 a

a dense sand has an effective friction angle of 43 and c0. a dry 2.8-inch diameter sample is tested in drained triaxial

  Calculate the chord lenght between stations on a curve

calculate the chord lenght between stations 75.00 and 75.00 on a circular curve with Da=5.5 degrees.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd