Relative humidity and temperature of resultant air stream

Assignment Help Mechanical Engineering
Reference no: EM13717418

Outside cool air at 15C and 40% relative humidity is mixed with inside air taken near the celling in a room at 32C and 70% relative humidity. Determine the relative humidity and temperature of the resultant air stream if the outside flow rate is 40 m^3/min and the inside flow rate is 20. m^3/min.

Reference no: EM13717418

Questions Cloud

Find gravitational potential energy of stone-earth system : A 0.31-kg stone is held 1.4 m above the top edge of water well and then dropped into it. The well has a depth of 4.8 m. what is the gravitational potential energy of the stone-Earth system when it reaches the bottom of the well
Air undergoes a polytrophic process in a piston cylinder : Air undergoes a polytrophic process in a piston cylinder assembly from p1=1 atm, T1=70 degrees F to p2=5 atm. Employing the ideal gas model with constant specific heats at 80 degrees F, determine the work and heat transfer per unit mass,
Diameter pipeline from the boiler to the turbine : In a steam power station, steam flows steadily through a 0.3 m diameter pipeline from the boiler to the turbine. In the boiler, the steam is at 5 MPa and 400 0 C while reaching the turbine it changes to 2 MPa and 3000 C. There is a loss of heat about..
Calculate the force which farmer needs to apply : A stubborn 110 kg pig sits down and refuses to move. Calculate the force which farmer needs to apply to budge the pig
Relative humidity and temperature of resultant air stream : Outside cool air at 15C and 40% relative humidity is mixed with inside air taken near the celling in a room at 32C and 70% relative humidity. Determine the relative humidity and temperature of the resultant air stream if the outside flow rate is 40 m..
What is the phase angle between voltage and current : Consider an RC circuit with R = 5600 Ohm, C = 1.70 x 10-6 F. The rms applied voltage is 120V at 60.0Hz. What is the phase angle between voltage and current
Evaluate what is the strength of the magnetic field : A metal rod 0.66m long moves with a speed of 2.3m/s perpendicular to a magnetic field. If the induced emf between the ends of the rod is 0.38V, what is the strength of the magnetic field
Parabolic weightless flight to train astronauts : A plane is doing a parabolic weightless flight to train astronauts. The plane gets up enough speed to shut off it's engine when it gets on a arc with radius of 1 km and glide to the top of the semicircle, where the gravity must be zero. What must the..
A crystal has an fcc crystal structure : A crystal has an fcc crystal structure. If a force (load) is applied along the [001] direction of the crystal, and the crystal has a yield strength of 50 MPa, what is the critical resolved shear stress of this crystal

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Calculate the final pressure and volume of the system

The process and volume relation is given p=(8-4v)bar for a non flow process ,where V is in cubic meter.If 130kJ of work is supplied to the system,calculate the final pressure and volume of the system.Take the initial volume as 0.5 cubic meter.

  First constant volume to 1000 kstate 2 then followed by a

a piston cylinder has 1.5 kg of air at 300 kand 150 kpa. it is now heated up in a two step process. first constant

  Kinetic and potential energy effects are negligible for the

a closed rgid tank contains 3kg of saturated water vapor initially at 140c. heat tranfer occurs and the pressure drops

  At what rate is the circumference of a wave changing

a stone is dropped into a lake causing circular waves whos radii increase at a contant rate of .5 m/s at what rate is the circumference of a wave changing when its radius is 4 meters?

  What would the person weigh on the moon

The acceleration due to gravity at sea level is g = 9.81 m/s2 . What is the person"s weight at sea level? The acceleration due to gravity on the moon is g = 1.62 m/s2 . What would the person weigh on the moon?

  Air at 293 k and 1 bar is blown over the rod at 25 ms

horizontal aluminum rod 1 cm in diameter and 10 cm long has both ends maintained at 363 k. air at 293 k and 1 bar is

  Design a crank-rocker mechanism with a time ratio of q

design a crank-rocker mechanism with a time ratio of q throw angle of deltasigmamax and time per cycle of t. specify

  Explain the first law of thermodynamics

Explain the first law of thermodynamics using the conversion of a fuel (gasoline or diesel) in an internal combustion engine. Provide sufficient details (sentences and illustration) to explain the first law.

  What is the initial temperature and initial internal energy

suppose 2 kg of water at 300 kpa has a specific volume of 0 5m3kg. as a result of heating at constant pressure the

  Analyze the static stability of the floating cylinder

A uniform solid circular cylinder of density 0.5p floats in a liquid of density p with its axis upright. The radius and height of the cylinder are R and 2R, respectively. Determine the mecacentric height and analyze the static stability of the floati..

  Review of druckers the coming of the new organization

How significant have advances in information and communication technologies since the late 1980's been on how we do business? And how have the major types of businesses that exist changed over this time?

  Applied loads and young''s modulus and poisson''s ratio

Applied Loads, Young's modulus, Poisson's ratio, The Young's modulus and the Poisson's ratio for copper are 124.8 GPa and 0.36 respectively. When a tensile load is applie to a 1.5cm diameter copper rod

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd