Find gravitational potential energy of stone-earth system

Assignment Help Physics
Reference no: EM13717422

Solve the all parts of following problem:

Problem: A 0.31-kg stone is held 1.4 m above the top edge of water well and then dropped into it. The well has a depth of 4.8 m.

Part A: Taking y = 0 at the top edge of the well, what is the gravitational potential energy of the stone-Earth system before the stone is released?

J

Part B: Taking y = 0 at the top edge of the well, what is the gravitational potential energy of the stone-Earth system when it reaches the bottom of the well?

J

Part C: What is the change in gravitational potential energy of the system from release to reaching the bottom of the well?

J

Write your solution in appropriate format and provide references. Thanks.

Reference no: EM13717422

Questions Cloud

Determine the length of a copper wire : Determine the length of a copper wire that has a resistance of 0.172 ohms and cross-sectional area of 7.85 x 10-5 m2. The resistivity of copper is 1.72 x 10-8 ohm•m
Estimate the velocity of the center of mass : A 2.04 kg particle has a velocity (2.09i - 2.98j) m/s, and a 2.91 kg particle has a velocity (0.92i + 5.98j) m/s. Find the velocity of the center of mass
Determine the specific work produced by the turbine : Steam flows through a turbine. The inlet stream is at 1200 KPa and 290 C. The pressure at the exit is 75 KPa. A) Determine the quality and temperature of the steam at the exit. B) Determine the specific work produced by the turbine.
What is the boiling heat transfer coefficient : Consider that you are boiling water near its critical heat flux in a pot on the stove without a lid (pressure is atmospheric). Suppose the hot burner has a surface temperature of 128 degrees Celsius. Assume a 1 square meter area. What is the boiling ..
Find gravitational potential energy of stone-earth system : A 0.31-kg stone is held 1.4 m above the top edge of water well and then dropped into it. The well has a depth of 4.8 m. what is the gravitational potential energy of the stone-Earth system when it reaches the bottom of the well
Air undergoes a polytrophic process in a piston cylinder : Air undergoes a polytrophic process in a piston cylinder assembly from p1=1 atm, T1=70 degrees F to p2=5 atm. Employing the ideal gas model with constant specific heats at 80 degrees F, determine the work and heat transfer per unit mass,
Diameter pipeline from the boiler to the turbine : In a steam power station, steam flows steadily through a 0.3 m diameter pipeline from the boiler to the turbine. In the boiler, the steam is at 5 MPa and 400 0 C while reaching the turbine it changes to 2 MPa and 3000 C. There is a loss of heat about..
Calculate the force which farmer needs to apply : A stubborn 110 kg pig sits down and refuses to move. Calculate the force which farmer needs to apply to budge the pig
Relative humidity and temperature of resultant air stream : Outside cool air at 15C and 40% relative humidity is mixed with inside air taken near the celling in a room at 32C and 70% relative humidity. Determine the relative humidity and temperature of the resultant air stream if the outside flow rate is 40 m..

Reviews

Write a Review

Physics Questions & Answers

  Find the magnitude of the resulting magnetic field

A sphere of radius R is uniformly charged to a total charge of Q. It is made to spin about an axis that passes through its center with an angular speed ω. Find the magnitude of the resulting magnetic field at the center of the sphere.

  Find the equivalent resistance

A resistor is in the shape of a cube, with each side of resistance  R . Find the equivalent resistance between any two of its adjacent corners.

  What is the electric field at the location

Question: Field and force with three charges? What is the electric field at the location of Q1, due to  Q 2 ?

  What is the maximum displacement of the bridge deck

What is the maximum displacement of the bridge deck?

  What is the magnitude of the current in the wire

What is the magnitude of the current in the wire as a function of time?

  Blackbody

Questions on blackbody, Infra-Red Detectors & Optic Lens and Digital Image.

  Gravity conveyor

Illustrate the cause of the components accelerating from rest down the conveyor.

  Calculate the dc voltage

Calculate the dc voltage applied to the circuit.

  Quadrupole moments in the shell model

Quadrupole moments in the shell model

  Determine the tension in each string

Determine the tension in each string

  Introductory mechanics: dynamics

Calculate the smallest coefficient of static friction necessary for mass A to remain stationary.

  Evaluate maximum altitude

Evaluate maximum altitude?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd