How much delay can be reduced by your strategy

Assignment Help Civil Engineering
Reference no: EM13563755

A traffic signal is set for a 1-minute cycle. The red and green phases on approach %u201CA%u201D are as follows: R=30sec (including amber phases) and G=30 sec.

1) If the flow to approach A is constant (no random fluctuations) at 20 veh/min and the saturation flow rate is 1veh/sec. Calculate the average delay for a typical car.

2) There exists one more intersection at downstream location, which is away 300m from the first intersection. If this intersection has traffic signal with same cycle time, draw queueing diagram for the second intersection, and find optimal traffic signal timing strategy to reduce delay. How much delay can be reduced by your strategy?

Reference no: EM13563755

Questions Cloud

Which alternative would be better if the equipment : A firm is deciding wheter to buy or rent equipment. How many days would they need to use the equipment each year to justify purchasing the equipment? To purchase equipmet/ Buy at $60,000
What is the amount in the account at the end of 20 years : A company deposits 10,000 every year for ten years in a bank. The company makes no deposits during the subsequent 10 years. If the bank pays 10% interest, what is the amount in the account at the end of 20 years?
Which community is transportation is more environmentally : Imagine two small towns of 1,000 people: Blacktop and Parktown. In the urban sprawl that is Blacktop, all the residents own fuel-efficient cars (15 km/liter) and travel an average of 20,000 km per year. Over in Parktown, the situation is somewhat dif..
Whether the project is economically stable : A project is being considered, benefits and costs are: Initial cost = $100,000. Additional cost at the end of year 1 = $50,000. Benefit at the end of year 1 = $0. Annual benefits at the end of Years
How much delay can be reduced by your strategy : There exists one more intersection at downstream location, which is away 300m from the first intersection. If this intersection has traffic signal with same cycle time, draw queueing diagram for the second intersection, and find optimal traffic signa..
What would be the fraction of trucks entering the section : Consider a highway section where traffic is stationary, all trucks travel at speed s and cars at speed v. If aerial surveillance revealed that trucks were a fraction p of the vehicles on a photograph, what would be the fraction of trucks entering the..
What steady-state concentration of co will be observed : A person may demonstrate observable effects on the central nervous system when exposed to carbon monoxide at a concentration of 50 ppm, may lose consciousness at a concentration of 250 ppm, and may die at a concentration of 750 ppm. A "typical" urban..
Determine the ph of water in a closed calcium carbonate : Determine the pH of water in a closed Calcium Carbonate Aquifer. Assume that the temperature is again 25oC, and that the aquifer material is pure Calcium Carbonate. Again you must list all species that exist in the system and all equations.
Give one reason why this should be considered by management : A chemical plant produces a process wastewater that contains a relatively high concentration of a small number of nontoxic organic compounds, but very low concentrations of solids or salts.

Reviews

Write a Review

Civil Engineering Questions & Answers

  When analyzing a truss using the method of sections to find

When analyzing a truss using the method of sections to find theforces in specific members. What is a good strategy to helpdecide where to make the cuts to separate the truss into separatesections?

  Determine at what rate must generated power be sold in order

The motor-generators installed with these pump-turbines have an efficiency of 0.85 when operating as motors and 0.91 when operating as generators. Each pump-turbine uses its own 100-m-long, 150-cm steel penstock.

  Calculate total mass of sludge dry solids generated per day

The flow rate of the treatment plant is 2,000 m3/d. a. Calculate the mass of sodium bicarbonate (NaHCO3) that would be required per day to replace the alkalinity consumed.

  Tangential component of the acceleration of the sled

Knowing that the coefficient of kinetic friction between a sled and the run is 0.10 and that the speed of the sled is 25 ft/s at B, determine the tangential component of the acceleration of the sled a) just before it reaches B, b) just after it pa..

  Determine the values of theta dot and theta dot at instant

The plate OAB forms an equilateral triangle which rotates counterclockwise with increasing speed about point O. If the normal and tangential components of acceleration of the centroid C

  Calculate what distances would be laid out

A rectangle commercial building must be laid out 200.00 ft wide and 300.00 ft long. if the steel tape used is 100.02 ft long under standard conditions, what distances would be laid out

  Determine what is the maximum daily mass of chloride

The pipe has a flow of 5 m3/s. The stream's chloride concentration just upstream of the pipe's dischage is 12 mg/L, and the runoff pipe's discharge has a chloride concentration of 40 mg/L. Chloride is a conservative substance.

  Estimate the land area in acres that must be purchased

The city has a stable population of 235,000 residents and the design criteria for the new landfill are as follows: MSW generation rate = 4.0 lb/(person-day); density of the compacted MSW in the landfill is 775 lb/yd3

  Determine what would the population be in 25 years

Nairobi has a birth rate of 3.3 individuals per individual per year and a death rate of 3.2 individuals per individual per year. If the carrying capacity were 105, what would the population be in 25 years

  Determine the specified dead loading for one interior

In the absence of motion, gravity, surface tension, electricity, and magnetism, the state of a pure substance is fixed by fixing at least:

  What compressive stress will be produced in the rails if the

The steel rails of a continuous, straight railroad track are each 60 ft long and are laid with spaces between their ends of 0.25 inches at 70 degrees F. At what temperature will the rails touch end to end? What compressive stress will be produced in ..

  Determine ratio of model discharge to prototype discharge

(a) Determine the ratio of model flow velocity to prototype flow velocity over the spillway for dynamic similitude. (b) Determine the ratio of model discharge to prototype discharge for dynamic similitude.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd