How many tons of coarse aggregate will be required to fill

Assignment Help Civil Engineering
Reference no: EM13315493

how many tons of coarse aggregate will be required to fill a trench 5 ft deep, 3 feet wide and 300 feet long? the coarse aggregate unit weight equals 93.6 lb per cu ft

Reference no: EM13315493

Questions Cloud

What is this temperature on the kelvin scale : The lowest outdoor temperature ever recorded on Earth was %u2212128.6 %u25E6F, recorded at Vostok Station, Antarctica, in 1983. What is this temperature on the Kelvin scale
What will be the concentration of tce in the aqueous phase : The dimensionless henry's constant for TCE at 25 degrees celsius is 0.4. A sealed glass vial is prepared that has an air volum of 4mL overlying an aquesous volume of 36mL.
Find the vertical component of the force : A non-uniform beam of length 4.41m and weight 1.02kg makes an angle of 25.2 with the horizontal. Find the vertical component of the force exerted on the beam by the pivot
Determine what is the intrinsic permeability of coarse sand : The hydraulic conductivity of a coarse sand was measured in the laboratory permeameter and found to be 1.03x10^-2 cm/s at 25 degrees C. What is the intrinsic permeability
How many tons of coarse aggregate will be required to fill : how many tons of coarse aggregate will be required to fill a trench 5 ft deep, 3 feet wide and 300 feet long. the coarse aggregate unit weight equals 93.6 lb per cu ft.
What is the induced emf in the entire solenoid : A solenoid of length 5.0 cm and diameter 0.87 cm is wound with 162 turns per cm. The current is decreasing at a rate of 38.0 A/s. What is the induced emf in the entire solenoid
Find the magnitude of the force that the car exerts on truck : A 1260 kg car pushes a 2140 kg truck that has a dead battery. When the driver steps on the accelerator, find the magnitude of the force that the car exerts on the truck?
How much would the water table need to be lowered : The specific yield of an unconfined aquifer is Sy = 0.15. How much, on average, would the water table need to be lowered (in m) in an area of 2.5 km^2 to release 6.5 x 10^5 m^3 of water from storage in this aquifer
Find what is the pressure when the nitrogen is reduced : One cubic metre of nitrogen at 40 degrees Celsius and 340KPa is compressed isothermally to .2(m^3). What is the pressure when the nitrogen is reduced to this volume. What is the modulus of elasticity at the beginning and end of the compression.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the velocity of slider block

Knowing that at t= 3s slider block C has moved 57 mm to the right, Determine the velocity of slider block C at t=0, (b) the acceleration of A and C, (c) the change in position of block A after 5s.

  Find the force that these gas generates on the top

the circular top of a can has a radius of .0320m. the pull-tab has an area of 3.8x10^-4 m^2. the absolute pressure of the carbon dioxide in the can is 1.40x10^5Pa. find the force that these gas generates on the top of a can?

  Determine undrained shear strength on compacted soil sample

An unconfined compression test was conducted on a compacted soil sample, 50 mm diameter by 100 mm long. The peak axial force recorded was 230 N and the sample shortened by 2 mm.

  Describe the present land capability classification system

Describe the present land capability classification system for agriculture in the caribbean, Identifying its limitations and propose recommendations. 200 word limit

  Critical review decision making of failed major construction

Critical review the decision making of a failed major construction/property project within the UK in the last ten years.

  How many gallons of water are contained in the tank

Develop a table that shows: 1) How many gallons of water are contained in the tank if the volume is measured in increments of 1 ft from the bottom to the top. 2) The mass of water at each increment, expressed in lbm.

  Find how many trucks are needed to service the backhoe

A haul fleet of trucks having a heaped capacity of 15 cy. is to be loaded by a hydraulic backhoe excavator (CT=.48 min.) with a 3 1/2 cy. heaped capacity. Assume the material is a wet loam that weighs 3380 lb/cy in the bank state

  What would the concentrationin the effuent be 7 days later

A lagoon with a volume of 1200 m^3 has been receiving a steady flow of a conservative waste at a rate of 100m^3/day for a long enough time to assume that steady-state conditions apply. The waste entering the lagoon has a concentration of 10mg/L.

  How many particles would be present in a cubic meter

How many particles would be present in a cubic meter of aerosol at the concentration of the U.S. PM-10 standard or 50 micrograms/cubic meter if the particles are .1 micrometer in diameter.

  Which pipe would be suggested to the axis chemical company

Axis Chemical Company needs you to design a gravity sewer to convey 1,750 GPM of toxic waste. The pipe is to be glass-lined reinforced concrete (n = 0.009). Which pipe would you suggest the Joker use

  What is the finished grade elevation on the curve at station

A sag vertical curve along an existing vertical alignment begins at station 23+45 and ends at station 30+25. The initial grade coming into the curve is -2% and the grade out is +5%. What is the finished grade elevation on the curve at station

  Determine the maximum shear stress in the shaft

A solid steel shaft with an outside diameter of 65 mm is subjected to a pure torque of 7,000 N-m. The shear modulus of the steel is G=80 GPa. Determine a. 1 The maximum shear stress in the shaft

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd