Determine what is the intrinsic permeability of coarse sand

Assignment Help Civil Engineering
Reference no: EM13315494

The hydraulic conductivity of a coarse sand was measured in the laboratory permeameter and found to be 1.03x10^-2 cm/s at 25 degrees C. What is the intrinsic permeability?

Reference no: EM13315494

Questions Cloud

Find the mass of the disk : A uniform disk of radius 0.517 m and unknown mass is constrained to rotate about a perpendicular axis through its center. Find the mass of the disk
What is this temperature on the kelvin scale : The lowest outdoor temperature ever recorded on Earth was %u2212128.6 %u25E6F, recorded at Vostok Station, Antarctica, in 1983. What is this temperature on the Kelvin scale
What will be the concentration of tce in the aqueous phase : The dimensionless henry's constant for TCE at 25 degrees celsius is 0.4. A sealed glass vial is prepared that has an air volum of 4mL overlying an aquesous volume of 36mL.
Find the vertical component of the force : A non-uniform beam of length 4.41m and weight 1.02kg makes an angle of 25.2 with the horizontal. Find the vertical component of the force exerted on the beam by the pivot
Determine what is the intrinsic permeability of coarse sand : The hydraulic conductivity of a coarse sand was measured in the laboratory permeameter and found to be 1.03x10^-2 cm/s at 25 degrees C. What is the intrinsic permeability
How many tons of coarse aggregate will be required to fill : how many tons of coarse aggregate will be required to fill a trench 5 ft deep, 3 feet wide and 300 feet long. the coarse aggregate unit weight equals 93.6 lb per cu ft.
What is the induced emf in the entire solenoid : A solenoid of length 5.0 cm and diameter 0.87 cm is wound with 162 turns per cm. The current is decreasing at a rate of 38.0 A/s. What is the induced emf in the entire solenoid
Find the magnitude of the force that the car exerts on truck : A 1260 kg car pushes a 2140 kg truck that has a dead battery. When the driver steps on the accelerator, find the magnitude of the force that the car exerts on the truck?
How much would the water table need to be lowered : The specific yield of an unconfined aquifer is Sy = 0.15. How much, on average, would the water table need to be lowered (in m) in an area of 2.5 km^2 to release 6.5 x 10^5 m^3 of water from storage in this aquifer

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the values of theta dot and theta dot at instant

The plate OAB forms an equilateral triangle which rotates counterclockwise with increasing speed about point O. If the normal and tangential components of acceleration of the centroid C

  What is the woods density in pounds per cubic foot

Wishing to use pine wood in a construction project a technician finds the density of Eastern White Pine is 0.373 g/cm^3 or g/cc. What is the wood's density in pounds per cubic foot

  Determine the maximum internal pressure in mpa

The rivets are 10 mm in diameter, spaced a distance s = 24.4 mm apart, and have an average shear strength of 35 MPa. Determine the maximum internal pressure in MPa if the rivets are not to shear.

  Geometric design and construction of a new two-lane road

Geometric design and construction of a new two-lane two-way road has been recently completed and now it is time for design pavement near Ballarat, Victoria.

  Calculate how many phases are present of liquid oxygen

A system consists of liquid oxygen in equilibrium with oxygen vapor. How many phases are present. The system undergoes a process during which some of the liquid is vaporized.

  Identify the forces that work against success of cladding

Identify the forces that work against the success of cladding systems in keeping the elements out.

  How far will the column of mercury in the tube be depressed

An open clean glass tube, having a diameter of 3 mm is inserted vertically into a dish of mercury at 20c .How far will the column of mercury (S.G =13.6) in the tube be depressed in (mm) given the following information. Theta = 130 and surface tens..

  Calculate the required plate area and the number of plates

An Electrostatic Precipitator must treat 500,000 acfm with 99% efficiency. Assuming an effective drift velocity of 0.4 ft/sec, calculate the required plate area in ft^2, and the number of plates if each is 20 ft tall by 10 ft long, and there are 4..

  Explain how to calculate the mcl for the acceptable risk

the water is pumped out of the aquifer at a rate of 2000 gpd, treat it with activated carbon and then put it back into the aquifer. At the flow rate how long until al the PCE is removed, assume carbon removed 100% of the PCE

  Determine the peak discharge that would result no ponds

Suppose a drainage basin has an area of 288 acres with a CN=55(Runoff Coef. of 0.30). Determine the peak discharge (in cfs) that would result from a 6.0in., 24-hr assuming there are no ponds and swampy areas.

  Why do owners prefer the design-build form of contracts

Why do owners prefer the design-build form of contracts when many of them know they can obtain better quality construction using other forms. What are the stages at which the designer will schedule design reviews.

  Calculate the elavations at vpc-vpt-high point and station

A 2000 ft vertical curve connects to a +3% grade to a -5% grade. If the vertical tangents intersect at station 52+60.55 and elevation 877.62 ft, calculate the elavations at the VPC, VPT, high point and station 54+00.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd