Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A four- lane undivided multilane highway ( two lanes in each direction) has 11- ft lanes and 5- ft shoulders. At one point along the highway there is a 4% upgrade that is 0.62 mi long. There are 15 access points along this grade. The peak- hour traffic volume has 2500 passenger cars and 200 trucks and buses ( no recreational vehicles), and 720 of these vehicles arrive in the most congested 15- min period. This traffic stream is primarily commuters. The measured free- flow speed is 55 mi/ h. To improve the level of service, the local transportation agency is considering reducing the number of access points by blocking some driveways and rerouting their traffic. How many of the 15 access points must be blocked to achieve LOS C?
The initial ultimate BOD after mixing of the Bergelmir Riveris 12.0 mg/L. The DO in the Bergelmir River after the wastewaterand river have mixed is at saturation. The river temperature is 10degrees celsius
Determine the % error n in replacing the sine and the tangent of an angle by the value of the angle in radians for angle values 5,10,20 degrees. Explain the qualitative difference between the sine and tangent results.
Block D sits freely on the homogeneous bar and experiences a gravitational force of 50N. Homogeneous bar AB experiences a gravitational force of 25 N. What is the force between the bar and block D?
For the following velocity profiles state whether they are steady or unsteady and whether they are 1-D, 2-D or 3-D.
A 1 cm diameter, 0.4 m long steel rod is to be used in an application where it will be subjected to an axial tensile force of 15kN. The factor of safety based on yield stress must be at least 1.5, and the axial deformation must not exceed 2 cm.
Two solid rods AB and BC are welded together at B and loaded as shown. Knowing that d1=50mm and d2=30mm, find average normal stress at the midsection of rod AB and rod BC.
It is possible to adjust the mean hole diameter. To what value should it be adjusted so as to maximize the probability that the clearance will be between 0.05 and 0.09 cm?
a wind tunnel is used to experimentally determine the lift force L and drag force D on a scale model of an aircraft. the bracket supporting the aircraft is fitted with an axial spring with stiffness k= 0.125 N/mm and a torsional spring with stiffn..
determine the location of the center of gravity of the cast aluminum block
Design a concrete footing to support a 16in by 16 in column that is 13 feet high with f'c= 6000 psi. The footing has a f'c=3000psi. Assume the the footing base is 5 ft below the grade and the soil is 100 lb/ft with an allowable pressure of 4500lb/ft ..
A nylon thread is to be subjected to a 10-N tension. Knowing that E=3.2 GPa, that the maximum allowable normal stress is 40 MPA, and that the length of the thread must not increase by more than 1%
Determine the base of the following arithmetic operation(assume that the base fo the stystem is x)
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd