Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A 35 percent-efficient coal-fired power plant with effective height of 100 m emits SO2 at a rate of 0.6 lb/10^6 Btu into the plant. If winds are assumed to be 4 m/s at the stack height and just over 3 m/s at 10 m, how large could the plant be (MW) without having the ground level SO2 exceed 365 micrograms/m^3?
No incisions are noted. Find the maximum axial tension using LRFD. Can we resist the same force in compression if the member is 10ft long?
A cylinder with a 6.0 in., diameter 12.0 in. height is put under a compresive load of 150 kips. The modulus of elasticity for this specimen is 8000 ksi and Poisson's ratio is 0.35. calculate the final length and the final diameter of this specuman..
The storage in a rectangular section irrigation channel is 20,000 m2 at a given time. Determine the storage 1 hour later if the average rates of inflow and outflow during the hour are 23 and 18 m3/s respectively.
What is the terminal settling velocity of a particle with a specific gravity of 1.4 and a diameter of 0.01 mm in 20 degrees celcius water. What is the smallest diameter particle of specific gravity 1.4
A 7 lb particle at rest is subjected to the action of its weight and forces F1= (2i+6j-2tk)lb, F2=(t^2i -4tj-1k) lb, and F3 =(-2ti) lb, where t is in seconds. the particle starts at the origin (0,0,0)
The water velocity is estimated to be 3.0 m/sec. Acetone has a density of 0.786 gm/mL and a half-life in water of 20.0 hr. Determine the concentration of acetone in the river due to this pulse release at distance of 2, 4, and 7 km from the site at..
Water flows in a 100 m long pipe at 3 m/s. If the water temperature is 20 degrees C, determine the minimum valve-closure time to avoid creating water hammer pressures. What is the maximum water-hammer pressure that can occur
this cuts it down to a single force that you have to solve for, regardless of what type of member it is. Prove that the forces are equal and that the lines of action are along an angle theta. HINT: Use to do equations of equilibrium.
On a clear summer afternoon with a wind speed of 3.20 m/s measured at 100 m elevation, the TSP (total suspended solids) concentration was found to be 1520 ug / m3 at a point 2 km downwind
The base line vector between the base and roving reciever is 8340m and has an accuracy of +/-(1to 2 cm +/-2ppm). What is the estimated uncertainty in the length of this vector
if the steel tape to be used is only 99.98 under standard conditions and if the temperature is 87 degree farenheit at the time of the measurement, how far away from the existing station mark at 0 + 79.23 will the surveyor have to measure to locate..
This distance is indicated correctly on a steel surveyor's tape whenused at a temperature of 70 degrees F and subjected to a pull of 10lbs. If in measuring a certain distance the tape indicatesthe distance to be 100 feet
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd