How high will the stream of water rise above the syringe

Assignment Help Civil Engineering
Reference no: EM13312104

A syringe is pointed vertically up in the air and a force of 5 lbs is applied to the plunger with a diameter of 0.5 inches.

Assuming no losses in the system how high will the stream of water rise above the syringe (assume the height of the needle is negligible).

Reference no: EM13312104

Questions Cloud

Introduction and background of your ce : Introduction and background of your CE
What is the maximum angle through which it may be scattered : When an x-ray photon with wavelength = 0.070nm strikes an electron at rest, What is the maximum angle through which it may be scattered
Determine what should the velocity for the model be : The prototype and model will both be in air, if the prototype has a velocity of 500 ft/s and a diameter of 30 ft, what should the velocity for the model be if the model diameter is 2 ft
Calculate the temperature of the steam at the exhaust : Consider a steam turbine in which the steam expands adiabatically. If the turbine consumes 1.00 kg steam each second, calculate the temperature of the steam at the exhaust
How high will the stream of water rise above the syringe : A syringe is pointed vertically up in the air and a force of 5 lbs is applied to the plunger with a diameter of 0.5 inches. Assuming no losses in the system how high will the stream of water rise above the syringe
What is the drift speed of the conduction electrons : A current of 3.50 A is carried by a copper wire of radius 0.87 mm. what is the drift speed of the conduction electrons
Determine the cycle length and distributuion of green : A simple four-leg intersection needs a 2-phase fixed-time signal. The critical flows in the N-S and E-w directions are 600 and 400 veh/hr, respectively, with a 0.95 peak-hour factor.
Research paper on a topic concerning a current or workplace : Write a research paper on a topic concerning a current or workplace issue or an area covered by the federal or state labour law or the national labour relation board case or issue.
How many helium balloons can be filled in the tank : a 150 L helium tank contains pure helium at a pressue of 1825 psig. How many 3.5L helium balloons can be filled from the helium in the tank? (Assume an atmospheric pressue (14.7 psia) and a temp of 298K.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the peak hour los of richmod highway

A new section of richmod highway is being designed as a six-lane facility (three in each direction) with a two-way, left-turn lane. Determine the peak hour LOS. Assumed base free flow speed = 55mi/h

  Determine volumetric flow rate in head across the turbine

The blade height is 1.0 m, and the inlet radius of the rotor is 7.0 m. The flow exits the turbine in a radial direction. (a) If the angle between the radial direction and the absolute velocity at the inlet is 30o

  Determine what are air flow and particulate concentration

Three streams of polluted air are combined prior to treatment in an electrostatic precipitator (ESP). The flow and particulate concentration of each stream are 600 cfm at150 mg/m^3, 700 cfm at 200 mg/m^3, and 500 cfm at 1000 mg/m^3.

  Define civil and environmental engineering

Civil and Environmental Engineering Question, 1. How is the problem of technology choice related to process selection and product design?

  Estimate how much carbon must be purcahsed

Estimate how much carbon (in pounds) must be purcahsed for a typical 2-bed carbon adsorption system to treat 5000 cfm of air at 95 degrees F and 1 atm. The air contains 600 ppm of styrene.

  What is min coefficient of road adhesion needed to achieve

The owners wish to achieve an initial acceleration from rest of 22 ft/(sec^2) on a level paved surface. What is the minimum coefficient of road adhesion needed to achieve this acceleration

  Determine lowest temperature at which 2-mm gap is closed

At a temperature of 9°C, a 2-mm gap exists between two polymer bars and a rigid support. Bars (1) and (2) have coefficients of thermal expansion of t1 = 102 x 10-6 /°C and t2 = 66 x 10-6/°C, respectively.

  Determine the value for cu and the cohesion intercept c

At failure, the respective minor and major principal stress values are 20 kPa and 46 kPa for one and 40 kPa and 80 kPa for sample two. From these data, determine the value for (phi)cu and the cohesion intercept c on the Mohr's circle shear stress ..

  Determine the shear-thrust and moment in the arch at point c

The three hinged arch is composed of segments of a circle. Support points A and D are not at the same level.Determine: (a) the horizontal and vertical components of reaction at A and D.

  What would the concentrationin the effuent be 7 days later

A lagoon with a volume of 1200 m^3 has been receiving a steady flow of a conservative waste at a rate of 100m^3/day for a long enough time to assume that steady-state conditions apply. The waste entering the lagoon has a concentration of 10mg/L.

  What biodegradation reaction rate coefficient be achieved

Assuming the lagoons are well mixed and that there are no losses or gains of water in the lagoon other than the sewage input, what biodegradation reaction rate coefficient (in day^-1) must be achieved for a first order reaction that governs the de..

  Determine the pressure head required from the pump

A pump is necessary to lift water from the clear well (reservoir) at a water treatment plant to a storage tower 50-ft high and some distance away. A flow rate of 15 cubic per second (cfs) is required (68F).

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd