How high can that person climb the ladder before the slip

Assignment Help Civil Engineering
Reference no: EM13306527

A ladder is supported by a horizontal floor and a vertical wall. Is 15 feet long and weighs 50 lbs, with the weight concentrated at its midlength. The ladder supports a person weighing 180 lbs. The coefficients of static friction between the ladder and the wall, and the ladder and the floor are both 0.30. The angle of the ladder to the floor is 60 degrees. How high can that person climb the ladder before it will slip?

Reference no: EM13306527

Questions Cloud

Huffman coding for compression : Huffman coding for compression - Starting from the beginning of the bit sequence, convert each sequence of 8 consecutive bits into 1 byte. If the number of bits is not a multiple of 8, pad the end of the bit sequence with 0s.
Calculate distance downwind xl at which the plume released : A powerplant is burning coal on a cold, clear winter morning at 8am with a wind speed of 2.6m/s measure at 30m and an inversion layer with its base height of 697m. The effective stack height is 30m.
Calculate the maximum coefficient of performance : It is desired to build a heat pump that has an output temperature of 31 °C. Calculate the maximum coefficient of performance for the pump when the input source is ground water at 8.1 °C
Describe the difference between the two locations at time t : The peak-hour volumes at two locations were counted and found to be equal. However, the PHFs were .85 at the first location and .60 at the second. Describe the difference between the two locations if t=5 min.
How high can that person climb the ladder before the slip : A ladder is supported by a horizontal floor and a vertical wall. Is 15 feet long and weighs 50 lbs, with the weight concentrated at its midlength. The ladder supports a person weighing 180 lbs.
Determine the maximum force that acted on the shell : A boad initially stationary at water,fires a shell in i direction,The shell's air speed =822 m/s.The shell was in the gu8n for .16s, and the force exerted on the shell decrease linearly fromthe initial force to zero over the firing interval.
When will the mass first reach a turning point : The frequency of a mass attached to a spring is 4Hz. At time t = 0, the mass has an initial displacement of 0.200m, When will the mass first reach a turning point
How high would it go if there were no air resistance : A projectile of mass 0.702 kg is shot straight up with an initial speed of 16.1 m/s. How high would it go if there were no air resistance
Whate are the relative fractions of ferrite and cementite : A Fe-.25 w/o Carbon alloy is sloly cooled to 700 degrees C. What is the composition of the Ferrite(alfa) phase and what is the compositon of the cementite(Fe3C) phase. Whate are the relative fractions of ferrite and cementite

Reviews

Write a Review

Civil Engineering Questions & Answers

  How to find degree of kinematic indeterminacy

how to find degree of kinematic indeterminacy

  Explain why a secant touches a circle at one point

1. The three isometric axes are: vertical and two axes 30 degrees from horizontal. 2. Oblique projection is a perspective projection method. 3. Isometric view represents a parallel projection method.

  Maximum total load that can be applied to a truss

How do you find the force ratio equation to determine the maximum total load that can be applied to a truss? Given a force of a member how do you find the force ratio?

  Define energy transfer in mechanical systems

Energy transfer in mechanical systems, A wheel is 800mm in diamiter and has a mass of 1000kg. on a horizontal surface without skidding, the vehicle accelerates uniformly at 0.5m/s^2 for 5 seconds.

  How many tons of water must be added to solids to achieve

Ten tons of a mixture of paper and other compostable materials has a moisture content of 7%. How many tons of water must be added to the solids to achieve a mixture with 50% moisture for composting

  Determine the length of the tangent of the curve

The proposed highway has two tangents of bearings N 45Degrees 54' 36" E and N 1 Degree 22' 30" W. The highway design engineer, attempting to obtain the best fit for the simple circular curve join these tangents, decides that the external is to be ..

  What is the probability that a random sample

What is the probability that a random sample of 20 time intervals between eruptions has a mean longer than 95 minutes?

  Determine how much money the homeowner would have saved

If t his house were heated instead by a heat pump that has an average COP of 2.4, determine how much money the homeowner would have saved that month. Assume the price of electric power is $0.085 per kW - hr.

  Explain what is the ph value of water containing

What is the pH value of water containing 0.005 M of an acid with a acid dissociation constant of 0.001 M. The dissociation of the acid in water can be represented as: HA H+ + A-

  Which machine should be chosen using an interest rate

North City must choose between two new snow-removal machines. The SuperBlower has a $70,000 first cost, a 20 year life, and an $8000 salvage value. At the end of 9 years , it will need a major overhaul costing $19,000.

  What temperature change is required to return the specimen

The elastic modulus is 40 GPa, the yield stress is 150 MPa, the ultimate stress is 525 MPa, and the ultimate strain is 0.38 (mm/mm). Perform the following tasks for this material.  compute the tangent modulus between yield stress and ultimate stres..

  Compute the volume of a waste sludge with water content

Compute the volume of a waste sludge with 96% water content containing 1000 lb of dry solids. If the moisture content is reduced to 92%, what is the sludge volume

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd