Calculate distance downwind xl at which the plume released

Assignment Help Civil Engineering
Reference no: EM13306530

A powerplant is burning coal on a cold, clear winter morning at 8am with a wind speed of 2.6m/s measure at 30m and an inversion layer with its base height of 697m. The effective stack height is 30m. Calculate the distance downwind XL at which the plume released will reach the inversion later and begin to mix downward.

Reference no: EM13306530

Questions Cloud

Obtain the index of refraction of the glass : Light is reflected from a glass coffee table. When the angle of incidence is 50.0 °, What is the index of refraction of the glass
Case study on vanust - a tale of two perspectives : Case study on Vanust - a tale of two perspectives
Will everything eventually be ethernet / csma/cd : Is Ethernet that good that it's the predominant form of LAN? Will everything eventually be Ethernet / CSMA/CD?
Huffman coding for compression : Huffman coding for compression - Starting from the beginning of the bit sequence, convert each sequence of 8 consecutive bits into 1 byte. If the number of bits is not a multiple of 8, pad the end of the bit sequence with 0s.
Calculate distance downwind xl at which the plume released : A powerplant is burning coal on a cold, clear winter morning at 8am with a wind speed of 2.6m/s measure at 30m and an inversion layer with its base height of 697m. The effective stack height is 30m.
Calculate the maximum coefficient of performance : It is desired to build a heat pump that has an output temperature of 31 °C. Calculate the maximum coefficient of performance for the pump when the input source is ground water at 8.1 °C
Describe the difference between the two locations at time t : The peak-hour volumes at two locations were counted and found to be equal. However, the PHFs were .85 at the first location and .60 at the second. Describe the difference between the two locations if t=5 min.
How high can that person climb the ladder before the slip : A ladder is supported by a horizontal floor and a vertical wall. Is 15 feet long and weighs 50 lbs, with the weight concentrated at its midlength. The ladder supports a person weighing 180 lbs.
Determine the maximum force that acted on the shell : A boad initially stationary at water,fires a shell in i direction,The shell's air speed =822 m/s.The shell was in the gu8n for .16s, and the force exerted on the shell decrease linearly fromthe initial force to zero over the firing interval.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculate available water capacity

given bulk density as 1300kg/cubic meter and field capacity as 22% by weight and permanent wilting point as 10% by weight calculate available water capacity.

  Determine the pressure within the tank using psf as unit

A water-filled U-tube manometer is used to measure the pressure inside a tank that contains air. The water level in the U-tube on the side that connects to the tank is 5 ft above the base of the tank.

  What will be shape of air-alcohol nd alcohol-water interface

A 10cm diameter vertical tank holds 20cm of water topped with 15cm of ethyl alcohol. The cylinder is rotated about its central axis at a rotation rate of 20 rad/s. (a) What will be the shape of the air-alcohol and alcohol-water interfaces (include ..

  Determine how long should the basin be

Assume Stoke's Law holds true for the following question. You are asked to desgin a settling basin. Flow rates are 16 million gallons/day. The basin must be 4m deep, and 4m wide. Particle size ranges from 0.2-50 mm in diameter.

  Write expression for engineering strain associated with a

A piece of wire is stretched from length l1 to length l2 (step A), and then from length l2 to length l3 (step B). (i) Write down an expression for the engineering strain associated with step A.

  Draw a flow net

Draw A flow net. Show flow lines, flow Channels, and Equipotential lines. Using flow nets, please provide an estimate of seepage rate below the dam. Your submittal will provide the basis for an environmental impact statement regarding the construc..

  What is expected behavior in charpy impact energy testing

Two identical alloy specimens are being evaluated for use in a new fuel rod design. One sample was exposed to a fast neutron flux of 9 X 10^23 neutrons/(cm2*sec) at a temperature of 323°K for six weeks in a test reactor.

  Determine what design speed was used for the curve

A horizontal curve was designed for a four-lane highway for adequate SSD. Lane widths are 12 feet, and the superelevation is 0.06 and was set assuming maximum fx. If the necessary sight distance required 52 feet of lateral clearance from the roadw..

  Determine which truck will cause more pavement damage

Truck B has an 8000-lb single axle and a 43,000-lb tandem axle. On a flexible pavement with a 3-inch hot-mix asphalt (HMA) wearing surface, a 6-inch soil-cement base, and an 8-inch crushed stone subbase, which truck will cause more pavement damage

  Determine the maximum power output of the pelton wheel

A Pelton wheel, located at an elevation of 200.0 m, is used to extract power from a reservoir at an elevation of 800 m. A penstock 1500 m long and 0.8 m in diameter connects the reservoir with the nozzle of the Pelton wheel.

  Explain what is the ph value of water containing

What is the pH value of water containing 0.005 M of an acid with a acid dissociation constant of 0.001 M. The dissociation of the acid in water can be represented as: HA H+ + A-

  Determine how much is on deposit after the 18th birhday

suppose helen deposits $4000 today and one year from today she deposits $1000. Each year she increases her deposit by $500 until she makes her last deposits on roberta's 18 birthday. how much is on deposit after the 18th birhday

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd