How far from shore is a sailboat when the top of its 8m

Assignment Help Civil Engineering
Reference no: EM13544547

1.On a large lake without waves, how far from shore is a sailboat when the top of its 8m mast disappears from view of a person whos eye height is 1.5 m above the waters edge?

2.The square gate shown is eccentrically pivoted so that it automatically opens at a certain value of h. What is that value in terms of l?

3.A wide flange steel beam shown in figure supports a permanent concrete masonry wall, floor slab; architectural finishes mechanical and electrical systems. Determine the dead uniform load in kips per linear foot acting on the beam.

4.How was this answered reached? what equation was used? equation of a line? could you please explain how the answer was reached and a detailed explanation of the math behind it.

Reference no: EM13544547

Questions Cloud

Find the axial load and the total change in each cross : A flat bar of cross section 20mm by 70mm elongates 4.0mm in a length of 2.0m as a result of axial load. If the elastic modulus is 199x106 kN/m2 and Poisson's ratio is 0.25 for the material, find the axial load and the total change in each cross secti..
Determine magnitude and direction of resultant force : Calculate the area of the triangle - exponential functions using logarithms - Determine the magnitude and direction of the resultant force.
Determine the normal stresses induced in the steel and in : The concrete post (Ec=3.6*10^6 psi and Ac= 5.5*10^-6/degrees F) is reinforced with six steel bars. each of 7/8-in diameter (Es=29*10^6 psi and As=6.5*10-6/ degrees F).
Notch fracture toughness show your supportin calculations : A Charpy V Notch test was conducted for an ASTM A572 Grade 50 bridge steel. the average values of the test results at four different test temperatires were found to be
How far from shore is a sailboat when the top of its 8m : How was this answered reached? what equation was used? equation of a line? could you please explain how the answer was reached and a detailed explanation of the math behind it.
Determine the youngs modulus of the steel alloy and the : a round steel alloy bar with a diameter of 0.75 in and a gauge length of 3.0 in was subjected to tension, with the results shown in the accompanying table. using a computer spread sheet program
Determine the braking efficiency of car : Two cars are traveling on level terrain at 60 mi/h on a road with a coefficient of adhesion of 0.8. The driver of car 1 has a 2.5-s perception/reaction time and the driver of car 2 has a 2.0-s perception/reaction time
What is the shortest height it should be : An engineering student has been given the assignment of designing a hydraulic holding system for a hay baling system. The system has four cylinders with 120 mm diameter pistons with a stroke of 0.320 m
Select a hydraulic pump size and a hydraulic cylinder size : An engineer is designing a hydraulic lift with a capacity of 10 tons. the moving parts of this lift weigh 1000lbf. the lift should raise the load to a height of 6ft in 20 seconds. This will be accomplished with a hydraulic pump

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine how far did the train travel during the time

A train moving at 100 km/hr decreases its speed to 80 km/hr in 3.5 seconds. How far, in meters, did the train travel during this time

  What is the rate of fuel used by the engine in the test

A container of petrol on a set of scales is used to measure the rate at which fuel is used by an engine under test. In one test the weight measured by the scales decreases by 25.0 N in 1 hour.

  Calculate energy needed to bring the soil to surface level

We are digging a hole to build a building. Calculate the energy needed to bring the soil to surface level. Remember the sides of the excavation lie at 45 degrees. Else, the whole would be constantly refilling itself.

  Determine the force arm oa exerts on the smooth cylinder

If arm OA rotates with a constant clockwise angular velocity of theta dot(first dirivatie)=1.5 rad/s. determine the force arm OA exerts on the smooth 4-lb cylinder B when theta=45 degrees.

  Determine what is the final pressure in the device

A .2kg mass of argon gas fills a .05m^3 piston-cylinder volume at a pressure of 400 kPa absolute. The piston induced pressure is changed until the volume expands to twice its original value, while the temperature remains constant.

  Determine largest distance d the concrete pipe may be moved

A crane is used to lift a concrete pipe weighing 10kN into place. For precision positioning, the worker at C can apply up a 800N force to cable AC. Determine the largest distance d the concrete pipe may be moved.

  Determine maximum moment in the beam if spinned at both ends

If the live load on a 30 foot long beam is 1.2 kip/feet and the dead load is 0.8 kip/feet determine the maximum moment in the beam (kip-ft) if it is pinned at both ends. Assume the weight of the steel is 0.3 kip/feet.

  Determine the total vertical stress the pore water pressure

A river 5 m deep flows over a sand deposit. The saturated unit weight of the sand is 18 kN/m^3 and the unit weight of water is 9.8 kN/m^3. At a depth of 5 m below the river bed:

  Design a horizontal curve with a 40-degree central angle

Design a horizontal curve with a 40-degree central angle (delta=40) for a two-lane road with 11-ft lanes. The design speed is 70 mi/h and superelevation is limited to 0.06ft/ft. Give radius, degree of curvature, and length of curve.

  Determine annual volume of lanfill comsumed in meter

A MSW landfill is being designed to handle solid waste generated by Binford at a rate of 50 Mg/d. It is expected that the waste will be delivered by compactor truck on a 5d/week basis.

  What the concentration in the effluent be 7 days later

A lagoon with volume 1,200 m3 has been receiving a steady flow of a conservative waste at a rate of 100 m3/day for a long enough time to assume that steady-state conditions apply. The waste entering the lagoon has a concentration of 10 mg/L.

  Find area that array of solar cells would need to power

Assume that a gallon of gas contains 114,000 BTUs of energy and that a brilliant engineer has created an 80 percent efficient solar cell. Find the area (in square smoots and in square feet) that an array of these solar cells

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd