How deep hole would be formed as a result of the excavation

Assignment Help Civil Engineering
Reference no: EM13309979

The Hubert H. Humphrey Metrodome in Minneapolis opened in 1982 at a cost of $55 million. To prepare for the footings, et cetera, 3.00x105 cubic yards of dirt were removed. The Metrodome's inflatable roof covers 10.0 acres and its interior volume is 60.0x103 cubic feet. During construction, 40.0x103cubic yards of concrete, 11.9x103 tons of reinforcing steel, and 5.00x102 tons of structural steel were utilized. The roof material includes an outer layer of Teflon-coated glass and an inner layer of woven fiberglass. Given this information, answer the following:

If removed evenly over the 10.0 acres, how deep a hole would be formed as a result of the excavation?

If the two-layer fiberglass roofing material has a mass of 0.667 lbm/ft2, what is the total mass of the roof?

If 10.0 inches of wet snow collected on the roof (this happened in 1982), what is the added mass on the roof? (Assume 1 inch of water equals 10 inches of snow).

Reference no: EM13309979

Questions Cloud

Find at what time is the emf zero : The current in a 90.0-mH inductor changes with time as I = 1.00t2 %u2013 6.00t (in SI units). At what time is the emf zero
Compute the ph when sodium hydroxide is added : Calculate the pH when 16.00 mL of 0.100 M sodium hydroxide is added to 10.00 mL of a 0.100 M phosphoric acid solution.
Determine void ratio and the porosity of undisturbed soil : A sample of undisturbed soil has a dry weight of 10 lb and volumen of 1 ft^3. If the specific gravity of the soil solids is 2.65, determine the void ratio and the porosity.
What is the force acting on the speaker : The diagram of a speaker has a mass of 50.0g and responds to a signal of 2.0 khz by moving back and forth a with an amplitude of 1.8 X10^-4 m at that frequency. what is the force acting on the speaker
How deep hole would be formed as a result of the excavation : The Metrodome's inflatable roof covers 10.0 acres and its interior volume is 60.0x103 cubic feet. During construction, 40.0x103cubic yards of concrete, 11.9x103 tons of reinforcing steel, and 5.00x102 tons of structural steel were utilized.
Explain fraction of collisions will have sufficient energy : What fraction of collisions will have sufficient energy to react for a gas whose activation energy is 68 kJ/mol at 25C
What is capacity of pump required to supply max discharge : What is the capacity of the pump required to supply maximum required discharge to the model, in CFS The length of time the model must be operated to check the equivalent of 36 hours of operation for the prototype operation, in decimal format hours..
Define hcl solution and naoh solution : Suppose that you have a supply of each of the acids listed in Table 11.1 and each of the bases listed in Table 11.2, as well as 1.00 M HCl solution and 1.00 M NaOH solution.
What emf will be produced in the coil : A coil with a radius of 2cm is wrapped with 400 turns of wire uniformly along its 20cm length. what EMF will be produced in the coil

Reviews

Write a Review

Civil Engineering Questions & Answers

  What is the minimum chain length for the application

A motorcycle sprocket on the rear wheel has a diameter of 24 cm, and trhe driver sprocket has a diameter of 4.0 cm. The driver sprocket shaft and rear axle are 60 cm apart.

  Compute the design compressive strength for lrfd

A w14X74 of A992 Steel has a length of 20 feet and fixed ends. Compute the design compressive strength for LRFD and the allowable compressive strength for ASD.

  Determine the elevation and stationing of the low point

A 1400-ft-long sag vertical curve (equal tangent)has a PVC at station 115 + 00 and elevation 750 ft. The initial grade is -3.5% and the final grade is +6.5%. Determine the elevation and stationing of the low point, PVI, and PVT

  Determine downstream depth necessary to form hydraulic jump

water flows at a velocity of 25 ft/s at a depth in a rectangular channel 16 feet wide. Determine the downstream depth necessary to form a hydraulic jump, the head loss through the jump and the horsepower dissipated in the jump.

  Determine the minimum green time for each approach

A traffic signal control is being designed for a four-leg intersection on a divided highway with the characteristics shown in the table below. Determine an appropriate length of the yellow interval for each approach and how you will provide it.

  Find acceleration in distance traveled in meters

given: Vf=Vi + a t and Sf=Si + Vi t + 1/2 a t Cedar points millennium force accelerates from 10 mph to 93 mph in 4.5 seconds. assuming acceleration is constant, find acceleration in ft/sec^2 and distance traveled in meters

  Hydraulic radius of the river

In that season, what are the hydraulic radius of the river, its mean velocity and volumetric discharge?

  Calculate temperature of the air at the exit of the nozzle

Assuming that the nozzle is well insulated and operating at steady state and that the air behaves as an ideal gas, calculate (a) the mass flow rate of air in kg/s, (b) the exit area of the nozzle in m^2,

  Detyermine what is the percent voids in the total mix

An asphalt concrete mixture includes 94% aggregate by weight. The specific gravities of aggregate and asphalt are 2.65 and 1.0, respectively. If the bulk density of themix is 147 pcf, what is the percent voids in the total mix

  Determine best hydraulic section for min wetted perimeter

A flume discharges 42.0 cfs on a slope of 0.50 ft in 1000 ft. The section is rectangular, and Manning's roughness coefficient is 0.012. Determine the best hydraulic section, i.e., the dimension for minimum wetted perimeter.

  Discuss energy storage scheme from a conversion efficiency

an electrical-generation utility sometimes pump liquid water into an elevated reservoir during periods of low electrical consumption. this water is used to generate electricity during periods when the demand for electricity exceeds the utilities a..

  Determine peak discharge if unit hydrograph is triangular

A hydrograph has a uniform rainfall intensity of 1.5 in/hr in the first hour, 2.0 in/hr in the second, and 0.75 in/hr in the third hour. Direct runoff (in inches) using the SCS method is 1.2in.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd