Find what is the builder capitalized cost to const the plant

Assignment Help Civil Engineering
Reference no: EM13306331

A home builder must construct a sewage treatment plant and deposit sufficient money in a perpetual trust fund to pay the $5000 per year operating cost and to replace the treatment plant every 40 years. The plant will cost $150,000, and future replacement plants will also cost $150,000 each. If the trust fund earn 8% interest, what is the builder's capitalized cost to const the plant and future replacements, and to pay the operating costs?

Reference no: EM13306331

Questions Cloud

Would it increase government spending or decrease it : Suppose that aggregate demand increases such that the amount of real output demanded rises by $7 billion at each price level. By what percentage will the price level increase? Will this inflation be demand-pull inflation or will it be cost-push infla..
Which languages give the programmer the freedom to choose : Is allowing the programmer this freedom a good language design strategy or not? Take a position and defend it.
Determine what is the porosity of the soil sample : The sample is placed in a 103 F oven overnight and is weighted again the next day. If the weight after drying is 0.85 lb and the specific gravity of the soil granuals is 2.65, what is the porosity of the soil sample
Sort the array in the descending order using pointers : Create functions for the following tasks and make sure to pass a pointer to the table (array) as an argument to each of them.
Find what is the builder capitalized cost to const the plant : A home builder must construct a sewage treatment plant and deposit sufficient money in a perpetual trust fund to pay the $5000 per year operating cost and to replace the treatment plant every 40 years.
Explain why this relation is not normalized : Assume that ProjectNumber determines ProjectName and explain why this relation is not normalized?
Determine what is the void ratio of the soil : A natural deposit of soild was found to have water content of 20% and to be 90% saturated. What is the void ratio of the soil
What is the accuracy of a two-bit predictor : What is the accuracy of a two-bit predictor, assuming the predictor starts off in the bottom left state? What if the pattern repeats forever?
Determine the fine grains of low plasticity : Soil A is micaceous with an average grain relative density of 2.80, and has a high plasticity in its fine fraction. The ground quartz-feldspathic B is, with an average relative density of 2.65 and fine grains of low plasticity.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the compression of each spring

The 75 lb block is released from rest 5 ft above the plate. Determine the compression of each spring when the block momentarily comes to rest after striking the plate.

  Determine the total axil deformation of the shaft

A solid composite shaft is subjected to a 2MN force. Section AB is red brass (E= 120 Gpa), and section BC is AISI 1010 steel (E=200GPa). Find the normal stress in each section and the total axil deformation of the shaft.

  Determine is there a chance that cavitation will occur

Temperature is 20°C. A constriction in the pipeline causes velocity to increase to 13 m/s within the constriction. Assuming that Bernoulli's equation applies (i.e. p + ½ ? v2 = constant), is there a chance that cavitation will occur

  What size square conduit is needed to transport

A 30mm pipe X 460mm rectangular duct carries air. What size square conduit is needed to transport 4m cube per sec of water at a distance of 45m and head loss of of 1.08m.

  How to determine the force that must be applied at a

The uniform load has a mass of 450 and is lifted using a uniform 35- strongback beam and four ropes. Determine the Tension in the ropes Determine the force that must be applied at A.

  What is the tce concentration in ppm if the tank is filled

What is the TCE concentration in ppm if the tank is held at (a) 4 degrees C and (b) 35 degrees C (c) What is the TCE concentration in ppm if the tank is filled with hexane instead of water Consider the temperature dependence of the density of wat..

  Calculate the compressive normal stress in the bar

A stainless steel (304) bar with a cross section of 0.2" x 0.4" is cut to a length of 30" and placed between two immovable walls at a  temperature of 40 degrees F. The operating temperature for the bar is 200 degrees F.

  Calculate the concentration of 137 cs in cows milk

After the Chernobyl accident, the concentration of 137Cs in milk was proportional to the concentration of 137Cs in the glass that cow consumed. The concentration in the grass was, in turn, proportional to the concentration in the soil.

  Calculate relative velocity of solute front through aquifer

Calculate the relative velocity of a solute front that is flowing through an aquifer. The organic carbon partitioning coefficient (Koc) is 6 mL/g and the friction of organic carbon in the soil is 2%.

  Determine unfactored dead load and live load on roof beam

Determine the unfactored dead load and live load on a typical interior roof beam, sketch the loading on the beam, and draw the shear and moment diagrams for the beam assuming the beam is simply-supported.

  Determine the horizontal reaction

Determine the horizontal reaction that is developed on the gate at C.

  Determine the sludge age and cell wastage flow rate

Assume: Suspended solids in effluent negligible Wastage is from aeration tank Yield coefficient = 0.4 Bacterial decay rate = 0.04 1/d Effluent BOD5 = 10mg/L F/M = 0.33 mg/mg*d BOD5 after primary settling = 150mg/L MLVSS = 1700mg/L MLSS = 1.4(MLVSS..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd