Find what are the probable genotype of the parent plants

Assignment Help Civil Engineering
Reference no: EM13326435

Color in a type of squash is controlled by a single gene. The squash can be either white or yellow, with white squash (W) dominant to yellow (w). if 1/2 of the offspring are white, what are the probable genotype(s) of the parent plants?

Reference no: EM13326435

Questions Cloud

Determine the net power delivered to the generator : Air enters the compressor at 98 kPa and 295 K at a rate of 10 kg/s and exits at 1 MPa and 620 K. Determine the net power delivered to the generator by the turbine.
Determine the velocity and the volume flow rate of the steam : Steam enters a nozzle at 400oC and 800 kPa with a velocity of 10 m/s, and leaves at 300oC and 200 kPa while losing heat at a rate of 25 kW. For an inlet area 0f 800 cm2, determine the velocity and the volume flow rate of the steam at the nozzle ex..
Calculate the rate enhancement caused by the enzyme : An uncatalyzed reaction has a rate of 4.2 x 10-7 sec-1. When an enzyme is added the rate is 3.2 x 104 sec-1. Calculate the rate enhancement caused by the enzyme.
What are biosynthetic pathways in cells anabolic produce atp : what are biosynthetic pathways in cells A) anabolic B) catabolic C) usually produce more atp than they consume D) release monmorsinto the cytoplasm
Find what are the probable genotype of the parent plants : Color in a type of squash is controlled by a single gene. The squash can be either white or yellow, with white squash (W) dominant to yellow (w). if 1/2 of the offspring are white, what are the probable genotype(s) of the parent plants
Determine the properties at the final state and the amount : Two tanks (Tank A and Tank B) are separated by a partition. Initially Tank A contains 2 kg of steam at 1 MPa and 300 ?C while Tank B contains 3 kg of saturated liquid-vapor mixture at 150oC with a vapor mass fraction of 50%
Find what is the velocity m per s in the upstream pipe : A pressure gage connected between the upstream pipe and throat section shows a pressure difference of 29 kPa. The gasoline velocity in the throat section is 14 m/s. What is the velocity (m/s) in the upstream pipe
Analyze the cycle from 1st and 2nd thermodynamics point view : A proposed combined cycle power plant is shown below. A gas turbine engine, the topping cycle, takes air at state 1 (T=300 K, P=100 kPa) and compress it irreversibly (hc=0.87) to state 2.
Determine the volume-temperature and pressure at all state : Air enters an air - standard Otto cycle with a pressure and temperature of 1 bar and 15 C respectively. The compression ratio is 9 and the bore and stroke of the cylinder are (10 cm, 12 cm).

Reviews

Write a Review

Civil Engineering Questions & Answers

  What will be the force in newtons required

A lunar module weights 1500 kg on earth where g = 9.75 mps2. On the surface of the moon where g = 1.70 mps2, what will be the force in Newtons required to accelerate the module at 10 mps2?

  How many cubic yards of soil must be excavated from pit

A 1000 cubic yard embankment is to be built using soil from a borrow pit. The properties of embankment and the borrow pit soil are given below: Embankment: Dry unit weight = 115 pcf; Water content = 15%

  What power must pump supply to system to pump the oil

What power must the pump supply to the system to pump the oil from the lower reservoir to the upper reservoir at a rate 0.20 m^3/s. Sketch the HGL and the EGL for the system.

  Predict the temperature required in an isothermal plug flow

Using the method of Lee et al., predict the temperature required in an isothermal plug flow incinerator to reduce the xylene level in a waste gas from 100 ppm to 10 ppm. Assume a residence time of 0.7 sec.

  Find what ratio of h by b gives the minimum value of nc

Repeat LEM(Limit Equilibrium Method) analysis in clay (undrained) using a circular failure surface, with the center of the circle a distance h above the edge of the footing. What ratio of h/B gives the minimum value of Nc

  Determine point of application from the base of wall

he top of the soil is level with the top of the wall, and the soil carries a uniformly distributed load of 500 psf. Calculate the total active earth force of the wall per linear foot and determine its point of application

  Determine cir and fdr with foamed asphalt

The pavement structure consists of 160 mm of hot-mix asphalt (HMA), 150 mm of granular base and 450 mm of subbase placed over silty clay subgrade. The pavement is 20 years old and its current PCI is 50.

  Determine intensities w1 and w2 of distributed loading actin

The wall footing is used to support the column load of 12,000 lb. Determine the intensities w1 and w2 of the distributed loading acting on the base of the footing for equilibrium

  Compute the pw for the pessimistic and optimistic

An energy efficiency project has a first cost of $300,000, a life of 10 years, and no salvage value. Assume that the interest rate is 9%. The most likely value for annual savings is $60,000.

  What are the interface design boundaries and issues

what are the interface design boundaries and issues for the design and installation of a new toilet for a building

  Determine volume of water on the land in acre-ft

if 25 acres of land recieved 3.5 inches of water from the irrigation district, determine volume of water on the land in acre-ft

  Annual power cost of the ro system

Is the system within membrane manufacturer's warranty requirement of maximum flux rate of 14 gfd? What is the annual power cost of the RO system?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd