### Find the probability of landing on the head side of the coin

Assignment Help Civil Engineering
##### Reference no: EM13298721

A coin is tossed and a single 6-sided die is rolled. Find the probability of landing on the head side of the coin and rolling a 3 on the die.

### Write a Review

#### Determine the difference in the rate of grade

indicate the conditons by a sketchand determine the difference in the rate of grade at the intersection of each of the following paris of slops.

#### Design a single angle strut connected to a gusset plate

Design a single angle strut connected to a gusset plate to carry 180k n factored load. The length of the strut between center to center intersection is 3m.

#### Introduction to consolidation settlements

Include immediate and consolidation settlements, but ignore secondary compression. In your calculation, use three sublayers with thicknesses of 4 ft, 8 ft and 16 ft for the top, middle and bottom layers. Ignore any settlement caused by the dense s..

#### Design a three story office building

Design a three story office building

#### Calculate the coefficient of permeability

The temperature was 200C, and the void ratio (e) of the soil was 0.43. Calculate the "Coefficient of Permeability" in "centimeters per second" (Given, k = (QL)÷(A Δh t)).

#### List five soil and water management strategies

List five soil and water management strategies appropriate for agricultural use of ultisols. 100-150 word limit.

#### Determine the height h of the steps

The elastic ball bounces down a flight of rigid stairs. Determine the height h of the steps if all the trajectories between successive steps are identical. Use e=0.85 and the initial velocity 6 m/s.neglect friction.(teta=70 degrees)

#### Magnitude of force to produce pure shear in cylindrical wall

A thin-walled cylindrical tank of radius r is subjected simultaneously to internal pressure p and a compressive force P through rigid end plates. Determine the magnitude of force P to produce pure shear in the cylindrical wall.

#### What is the distiniction b/n point and non point sources

what is the distiniction b/n point and non point sources of water pollution and thier varation with surface and ground water?

#### Determine how many units of each product company should make

The number of hours on each machine required to produce a product is given in the following table, along with the number of hours available per week on each type of machine. Assume that the company can sell everything it produces.

#### Define what must the drivers eye height in the van be

A civil engineering student contends that 60 mph is safe in a van because of the higher driver's eye height. If all other design inputs are standard, what must the driver's eye height in the van be for the student's claim to be valid

#### What is the maximum grade the vehicle could ascend

the engine develops a maximum torque of 210ft-lb at 3600 rev/min. what is the maximum grade this vehicle could ascend, on a paved surface, while the engine is developing maximum torque (assume that the available tractive effort is the engine-gener..

#### Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!