Find the normal strains in these two directions

Assignment Help Civil Engineering
Reference no: EM13533377

The Young’s modulus and Poisson ratio are given by E andν, respectively.

If the normal stresses in the x and y direction are given byσx and σy, find the normal strains in these two directions.

If the normal strains in the x and y direction are given by ox andoy, find the normal stresses in these two directions.

Reference no: EM13533377

Questions Cloud

What direction should the boat have been headed to actually : To cross a river that is 1 km wide, with a current of 6km/h, a novice boatskipper holds the bow of the boat perpindicularto the far river bank, intending to cross to a point directly across the river from the launch point.
How much settlement has occurred when the time factor is : If the final consolidation settlement is expected to be 1.0m, how much settlement has occurred when the time factor is 0.2 andwhen it is 0.7?
Dynamic viscosity of the liquid between the plates : The relative velocity of two infinitely wide parallel plates thatare 1cm apart is 10cm/s. If the dynamic viscosity of the liquid between the plates is 0.001 N s/m2 what is the shear stress between the plates?
Calculate the consolidation settlement expected : For the profile shown, the initial ground water table is 5 ft belowthe surface. A proposed dewatering project will cause the watertable to drop 10 ft from the original level. Consolidation tests performed on clay samples produced the following result..
Find the normal strains in these two directions : If the normal stresses in the x and y direction are given byσx and σy, find the normal strains in these two directions.
Determine the rate of evaporation of water : Water is to be boiledat sea level in a 30 cm diameter stainless steel pan on top of a3-kW electric burner. If60% of the heat generated by the burner is transferred to thewater during boiling, determinethe rate of evaporation of water.
Determine which is a better site for wind power generation : Two sites are being considered for wind power generation. In the first site, the wind blows steadily at 7 m/s for 3000 hours per year, whereas the second site the wind blows at 10m/s for 2000 hours per year
Four forces act on a small airplane : The slope distance and zenith angle measured from point P to pointQ were 1876.253m and 87.33'24 degrees, respectively. The instrumentand rod target heights were equal. If the elevation of point P is227.965m, above datum, what is the elevation of poin..
How long will it take him to reach the same velocity the : For the free-falling patachutist with linear drag, assume a firstjumper is 70 kg and has a drag coefficient of of 12 kg/s. If a second jumper has a dragcoefficient of 15 kg/s and a mass of 75 kg, how long will it take him to reach the same velocity t..

Reviews

Write a Review

 

Civil Engineering Questions & Answers

  Determine the required value of the mass

a 1 meter diameter cylindrical mass is connected to a 2 meter wide rectangular gate. the gate is to open when the water level drops below 2.5 meters. Determine the required value of the mass of the cylinder in kgs.

  How to determine free-flow travel time on the route

Route 1 has a free flow travel time of 4 mintutes and travel time increases by 3 minutes and for each additonal 1000 vehicle in flow, and route 2 has a free flow travel time of "b" minutes and travel time increases

  A certain stell tape for wich the the coefficient of expans

A certain stell tape, for wich the the coefficient of expansion is 0.00000645, is exactly 100 ft long68 farenheit. at 15 farenheiit the length of the tape is howmany feet?

  Determine what is the specific yield of the aquifer material

The area is about 100,000 ha, the ground water pumping about 500 million m3 per year, and the water table drop about 3 m per year. Assuming no replenishment, what is the specific yield of the aquifer material

  Determine the true horizontal legth of the distance measured

A 100-ft steel tape was used in the field to measure a distance of 247.53 ft. the following data represents the conditions in the field at the time of measurement: tempreture = 41 F, tension = 30 ib, and tape supported at ends only.

  What criteria should zachary use evaluate the project

what criteria should Zachary use evaluate the project ?

  What is total mass of water raised during the minute period

One method used to store energy during times of low demand is by pumping water uphill into a reservoir. When energy demand exceeds the output produced by power plants, the water is released, moves downhill, and is converted into electricity by a t..

  Determine suitable footing dimensions to suit the bearing

Determine suitable footing dimensions to suit the bearing capacity of 100kPa with a factor of safety 2.4

  Find what is the concentration of pepper in mg per l

one gram of pepper is placed into a 100 mL beaker, and the beaker is filled with water to the 100 mL mark. What is the concentration of pepper in mg/L. What should one assume in this problem

  Determine allowable moment about the horizontal neutral axis

Determine the allowable moment about the horizontal neutral axis that a timber beam with nominal size 50 X 100 can resist without exceeding the allowable stress of 10 MPa.

  Determine the acceleration of the automobile immediately

A motorist is traveling on a curved section of highway of radius 2500ft at the speed of 60 mi/hr. the motorist suddenly applies the brakes, causing the automobile to slow down at a constant rate.

  Determine the maximum axial lrfd safe load for the column

A W14x68 section of A992, Grade 50 steel, is used as a steel column with a total unbraced height of 12 ft. The column ends are both fixed. Determine the maximum axial LRFD safe load for this column

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd